Boost Cooler

[Silver o1]

Can you use a snow boost cooler with a eaton or kenne bell? Some people say that the water wears on the rotors/screws. Anybody shed some light on this.

 

[type911]

As you know the eaton can get pretty hot. There has been concern that the METH/Water evaperates on the screws. There fore only minimumly reaching the combustion chamber.

 

[iczar1]

/bump

 

[Posi]

It seems for it to really work you would need to locate it in the lower manifold. That way it's past the blower and would work with the factory intercooler! I think Joe DaSilva did it on a KB car in one of the magazines so just call DaSilva Racing and ask for him!

 

[big frank]

Kenne Bell talks about using them in some of their literature. You might check their website.

 

[Stroked03]

I have it one my car and to be honest spend your money else where not worth it, the only way it worked for me was to pull a bout 6 degrees of timing and spray directly on the intercooler, i orginally had it on the tube but once it goes through the blower i noticed the temp spiked up 10 degrees.