I have a KB 2.6 with stock 3 3/4 pulley.When im revved up about 3500 rpms an stomp it the boost instantly goes to 14 psi then as it goes up to 16-17
Is the boost suppose to creep up as you go to redline?
Is it better to have a bigger pulley and advance the timing or smaller pulley and delay the timing?
Would one build boost faster than the other for more power?
Should i upgrade to a 3 1/2 for 18psi or 3 1/4 for 20psi?
What mods would be the next step for some aded power?
Also what has to be done to run cams?
Im really not looking for run E85 or nitrous. Howerver open to ideas.
Mods are 2.6KB,3 3/4 pulley, 60lbs injectors,JLT intake,Mecto DB Idlers, Spec Stage 3,26 Spline shaft, Im not sure about fuel rails, pumps or wiring.
Is the boost suppose to creep up as you go to redline?
Is it better to have a bigger pulley and advance the timing or smaller pulley and delay the timing?
Would one build boost faster than the other for more power?
Should i upgrade to a 3 1/2 for 18psi or 3 1/4 for 20psi?
What mods would be the next step for some aded power?
Also what has to be done to run cams?
Im really not looking for run E85 or nitrous. Howerver open to ideas.
Mods are 2.6KB,3 3/4 pulley, 60lbs injectors,JLT intake,Mecto DB Idlers, Spec Stage 3,26 Spline shaft, Im not sure about fuel rails, pumps or wiring.
Last edited:
