Boost-a-pump installed, please confirm wire splice.

[mnypit]

Finished the BAP install on my 2001 S/C Cobra. Since KB is not open until Monday, can someone confirm that I in fact installed in properly (I am not an electrical engineer ). The wire I spliced and tapped into is the Brown/Pink wire located at the fuel tank harness connector. Obviously this is after the FPDM. So basically I have current coming from the FPDM, going into and out of the BAP, going to the Fuel Pump, then back to the FPDM and then to ground somwhere. Is this right?

Thanks for your help. KB instructions dont include info for returnless systems (at least mine doesnt).

Steve

 

[Shadowgray03]

I spliced same wire. The fuse should be on the end coming from the FPDM and the nonfused side out of BAP goes to other half of cut wire.

 

[mnypit]

Thanks Shadowgray03, I wired it just as you described. I do appreciate it!

Steve