Blower swap, what do I need

[Autocross Cobra]

I have a Steggy stage6 ported blower I bought a few months ago, I plan to swap this weekend,
--what do I need to swap it such as gaskets or torque to yield bolts etc etc??? What misc items will I need?
--Where/how do you put oil in the stock blower?
--Do u have to remove the lower intake?
--torque specs?

 

[Soap]

All you need is some RTV for between the IC and the blower, all other gaskets and bolts are reusable. Oil goes in the hole in the front of the case (small allen head screw).

You do not need to remove the lower intake.

--Joe

 

[apex svt]

I remove the lower intake when I do it. Guess you can do it either way. Parts I used:
New intake manifold gaskets
Intercooler to manifold gasket
Blower gasket
Rtv for the intercooler to blower

I believe the torque specs are 89 in/lbs. there is a thread or 2 that say 15ftlbs do not use this number. You will break bolts.
The blower gasket and intake manifold gaskets are optional, they are reusable.

 

[cj428mach]

A twin screw or tvs.

 

[jrgoffin]

It's all spelled out in the service manual. The sections pertaining to just the blower swap are in PDF form at the end of this section:

http://www.terminator-cobra.com/engine.htm#Ported_Eaton_

 

[Autocross Cobra]

Thanks for all the info guys, and thanks for the link, looks very informative.

 

[speedoflife]

Thanks for all the info guys, and thanks for the link, looks very informative.

Don't forget to clean your intercooler while you're in there!