I have decided to go another route with the car and am parting out some stuff from the cobra. All parts were off my 03 cobra with 58k miles unless otherwise specified in good working condition. Everything was pulled off the car this past week. All prices are for local pickup but will ship at buyer’s expense. Please let me know if you have any questions!
- 2.9L Whipple w/ 3.125” pulley (non-crusher, lightly ported inlet, Whipple boost bypass, EGR delete plate, 10k miles) - SOLD
- Magnaflow mufflers with welded on dumps - $100
- FORE fuel rails (10k miles) - SOLD
- Accufab single blade throttle body (9k miles) - SOLD
- FRPP 80lb injectors (15k miles) - SOLD
- Thump Racing tensioner with 76mm idler (400 miles) - $350
- Stock lower intake manifold - $425
- Stock intercooler - SOLD
- 3 used Gates K080806HD (81.125”) and 1 new Gates K080797HD (80.125”) belts - $20 each
- SCT BA3000 MAF (10k miles) - SOLD
- Metco lower pulley setup (4lb and 2lb rings) - SOLD
- Lower intake waterneck with intercooler tubes and new o-rings - SOLD
- Start ‘n charge 160A alternator with 3.2” pulley (recently rebuilt with 1,500 miles) - SOLD
- Billetflow snub idler and pullies (cosmetic marks on some pulley faces, never caused issues with belts) - SOLD
- Pulley bridge - $250
- Alternator brackets - $150
- Radiator fan - $40
- Air conditioning system (o-rings need replaced) - $150
- Thermostat housing with Reische 170* thermostat - $80
- 2.9L Whipple w/ 3.125” pulley (non-crusher, lightly ported inlet, Whipple boost bypass, EGR delete plate, 10k miles) - SOLD
- Magnaflow mufflers with welded on dumps - $100
- FORE fuel rails (10k miles) - SOLD
- Accufab single blade throttle body (9k miles) - SOLD
- FRPP 80lb injectors (15k miles) - SOLD
- Thump Racing tensioner with 76mm idler (400 miles) - $350
- Stock lower intake manifold - $425
- Stock intercooler - SOLD
- 3 used Gates K080806HD (81.125”) and 1 new Gates K080797HD (80.125”) belts - $20 each
- SCT BA3000 MAF (10k miles) - SOLD
- Metco lower pulley setup (4lb and 2lb rings) - SOLD
- Lower intake waterneck with intercooler tubes and new o-rings - SOLD
- Start ‘n charge 160A alternator with 3.2” pulley (recently rebuilt with 1,500 miles) - SOLD
- Billetflow snub idler and pullies (cosmetic marks on some pulley faces, never caused issues with belts) - SOLD
- Pulley bridge - $250
- Alternator brackets - $150
- Radiator fan - $40
- Air conditioning system (o-rings need replaced) - $150
- Thermostat housing with Reische 170* thermostat - $80
Last edited: