I'm trying to install a new Billetflow supercharger pulley hub onto my Eaton but have ran into a snag.
I have the Billetflow install tool, but it appears the threads are messed up on the blower shaft as I can't get the install tool to thread easily into the shaft.
Any ideas of how I should proceed? I thought about just forcing the install threaded pin into it, but how do even do that when the shaft just spins freely.
Thought about re-tapping with the correct thread size (M8x1.25) but again, how do I do this when the shaft just spins?
Any advice, or ideas I'm all ears! Thanks!
I have the Billetflow install tool, but it appears the threads are messed up on the blower shaft as I can't get the install tool to thread easily into the shaft.
Any ideas of how I should proceed? I thought about just forcing the install threaded pin into it, but how do even do that when the shaft just spins freely.
Thought about re-tapping with the correct thread size (M8x1.25) but again, how do I do this when the shaft just spins?
Any advice, or ideas I'm all ears! Thanks!