Big Stuff 3 complete mod motor setup

[Roush9703]

I'm selling my complete Big Stuff 3 set up. It was used to run a 4v mod motor. It will come with everything to install in your modular motor'd mustang. Every harness, replacement sensor, correct IAC valve and of course the BS3 box. It will also include plug wires and billet plates to mount the coil packs on a 4v valve cover. The plates will not mount on a 2v valve cover. Everything is about two years old. The only pictures I have are of the set up installed in the car. I'm asking $2250 for the entire setup

 

[Sneeks2nv]

whats the model number on the box, it should start with 004-00???? thanks

 

[Roush9703]

P/n:bs3-004-006
f/w:mod_l
d/c:092907
s/n:2444a

mod cop
dai

That is what is on the sticker on the underside of the box. I can take a picture of it if you would like also.

 

[Roush9703]

got a lot of inquires about this today but no buyer yet so I'm sending it back up.

 

[4sdvenom]

Why are you selling?

 

[Roush9703]

Why are you selling?

I'm parting out the car.

 

[Roush9703]

Sold

 

[76mmturbo]

I'm selling my complete Big Stuff 3 set up. It was used to run a 4v mod motor. It will come with everything to install in your modular motor'd mustang. Every harness, replacement sensor, correct IAC valve and of course the BS3 box. It will also include plug wires and billet plates to mount the coil packs on a 4v valve cover. The plates will not mount on a 2v valve cover. Everything is about two years old. The only pictures I have are of the set up installed in the car. I'm asking $2250 for the entire setup

Sorry I know this is a super old post but.
Did you use a gm IAC?