bent rod
- Thread starter streetassasin
- Start date
thats definitely not a forged rod
no idea, saw it on another forum
Should have used the Terminator block!
its out of giant container ships, there massive motors that you literally walk through while there running to inspect. Pretty amazing sh*t. The giant "green building" in the back ground is the block of the motor, lol
Last edited:
too much boost.
repost... its from the worlds most powerful motor.. goes like 85 rpm or something like that.. with 1million plus hp...
GoatSlayer
Banned
I never understand why cobra owners never get a tune when they put an upper pulley!
I'm pretty sure its no wheres near 1 million HP. One of, if not the largest motors used today is the Warsila Sulzer RTA96-C, that produces 95,000HP at 105RPM.
i was exagerating the number..
here is the motor
Worlds Biggest [email protected]
the one you were talking about lol
only 95K hp? Thats cam only ls1 numbers
I sell these engines for land based power generation. One MAN 12 cyl 90MC type is about USD 36Mill. and produces about 50MW. They are pretty big.
The crank alone is about 380ton. The crank are built up with free forge throws mainly produced at Kobe Steel in Japan on their 13.800ton hydraulic press.
The crank alone is about 380ton. The crank are built up with free forge throws mainly produced at Kobe Steel in Japan on their 13.800ton hydraulic press.
I knew I shoulda went forged when I bolted up that new blower.
You exaggerate everything you post in here. :rollseyes
HE should of been checking his A/F when doing that pull, "danger to manifold"!!!!
Users who are viewing this thread
