I'm not sure what forum to put my question in... but here it is...
I just purchased an AutoMeter Vac/Boost gauge (Lunar series). My question its the gauge needle is not centered in the box... its leaning more towards the Boost side then the middle. Is there anyway to adjust this.. or should I just not worry about it...??
Thanks, Rick
I just purchased an AutoMeter Vac/Boost gauge (Lunar series). My question its the gauge needle is not centered in the box... its leaning more towards the Boost side then the middle. Is there anyway to adjust this.. or should I just not worry about it...??
Thanks, Rick