Are you Over 600rwhp with your non-built Coyote?

burke985

Active Member
Established Member
Joined
Oct 5, 2012
Messages
1,581
Location
Slidell
3000 miles ,but i dont track my car and only do the occasional spirited sprint on the interstate from time to time. I expect my car to live a long time as its kinda a DD but not really, only gets driven 2 weeks a month and i will be adding the Roush CAI soon which will put me close to 650 whp, see about 9-9.5 on the boost gauge now
 
Last edited:

mhyjek

Active Member
Established Member
Joined
Jul 30, 2012
Messages
1,037
Location
NJ
BMRGT-VMPTVS-79mm.jpg

At 2k 100 ft lb more torque at 4k almost 200 more tq. FTW PD blowers make it in a hurry and people on these boards say the TQ booster for centri will stress the motors more... Nice power!
 

keoni1984

New Member
Established Member
Joined
Jun 15, 2012
Messages
226
Location
Jacksboro, TN
675 whp 616 tq @ 8psi on 91 tune
CPR single turbo
KB BAP
Boss manifold
Stock internals
Approximately 29k miles on the car. Roughly 5,500 miles with the turbo kit.

Shauntunegraph_zps3c466cb9.jpg

rebuiltturbo_zps00022f37.jpg
 
Last edited:

manolith

I Wanna go fast.
Established Member
Joined
May 6, 2011
Messages
2,856
Location
miami
my car made 620rwhp and 458rwtq on the stock paxton pulley and 14 degrees of peak timing. about 8.5psi. right now it is runing the 3.6 pulley and makes 10psi and it runs 16.25 degrees of timing on the top end and also we took alot of fuel out of it especially on the mid range so my guess will say that its making anywhere from 650 to 680rwhp and around 500rwtq.

[youtube_browser]jFoL_PFWr74[/youtube_browser]
 

bam2012@TBR

Authorized Vendor
Authorized Vendor
Joined
Oct 23, 2011
Messages
697
Location
virginia beach, va
Last dyno numbers were 671/535 with 3.6" pulley and corn. Should have picked up a little with the 8rib 3.15 and wastegate setup. Dyno day on the 21st.
 

mastwolf

4800fps = Mach1 in h2o
Established Member
Joined
Feb 18, 2005
Messages
1,396
Location
FL/Texas
CPR Single Turbo Kit @ ~7lbs

20130909_212107_zps3d6e69fa.jpg


Single 75/87 borg warner on a t4 housing
North Of 750rwhp STD on less that 8lbs.
54,000+ Miles
:banana:
 

grnenvy

New Member
Established Member
Joined
Nov 27, 2002
Messages
3,486
Location
From Philly now Tampa, Fl
There are a lot of guys making over 600rwhp with the stock bottom end. The question is for how long and if it's the oil pump gears that go it's going to be expensive to fix.
I'll tell u this the 6R80 doesn't like BIG HP either my trans is wasted from my last dyno session.
 

manolith

I Wanna go fast.
Established Member
Joined
May 6, 2011
Messages
2,856
Location
miami
the 6r80 can handle a shit load of hp but if its not tuned right it will be toasted before the first 1/4 pass. there is one in particular that i know off that was destroyed by a tuner we all know.
 

11Sec_Lx

Well-Known Member
Established Member
Joined
May 31, 2003
Messages
3,098
Location
Indianapolis
I don't have dyno numbers, but to run my numbers at my weight I would have to be around 600 or so. 2500 miles like that. I don't abuse my car, but it does see boost every time I drive it. I'm planning oil pump gears and a balancer before modding further.
 

Users who are viewing this thread



Top