Anyone think a V2 S trim can break the 600rwhp mark?

[Chances50]

Ill be puting my Mach back together this weekend and plan to head to Gearheads performance in Arlington in the next week or so. I have a v2 S trim treadstone fmic should be seeing 16-17lbs, stock heads, cobra intake cams and full exhaust return fuel system on e85. What do you guys think?

 

[98 Saleen Cobra]

yup it should.. :beer:

 

[SVTPete83]

You should be there man! Good luck

 

[Stanger00]

It will be close...

My car with trickflow 2 valve heads and 4r70w made 573hp on AED's dyno with a Vortech Si Trim and 91 octane and timing was only at 14*. So you should be able to make it.

 

[Chances50]

How much boost were you seeing and with what pulley combo?

 

[98 Saleen Cobra]

He's running 10.2 compression E85 and 17psi lol.. I'd be shocked if he wasn't closer to 700.. It's not that the blower can't handle it, but the more power you make N/A the more power you'll make when you add boost.

 

[Stanger00]

Oh yeah my car is 8.7:1 compression. Check the pulley thread that 98 made. I have my info in there, I'm on my phone right now.

 

[Chances50]

I don't think it'll see anywhere near 700, I'll be surprised if it breaks 620.

 

[98 Saleen Cobra]

Oh it will if you push 17psi and 23 degrees or more of timing it will.

 

[pacific4v]

Id say 600 easy, with that compression and the timing you can run on e85 i would think 16-17psi would put u around 630-650rwhp. Plus you have the good mach1 c-heads. As long as it responds well to the timing it'll make good numbers.

 

[phillipmach1]

Shit my car made 569 rwhp with stock engine internals and that was at 12.7 psi and +25 on the timing so 17 psi and 20 plus on the timing i say 700.

 

[98 N/A 4V]

600rwhp was already done about 8-10yrs ago on a stock b-head cobra.

 

[Chances50]

It made 536rwhp on 9lbs and 22* timing before so maybe just maybe itll surprise me.

 

[TVSCobra]

Nice man!
Keep us posted. Good luck.

 

[chevpwr]

Good luck Chance!!!

 

[Chances50]

Thanks Lee!

I've ran into one problem after the next, I finally got it back together, ended up have to get the heads milled so compression went up to 10.4-5:1, now my dang electric fan on come on traced it down to a few tore up wires and might have a fried CCRM, should know for sure tomorrow. Have the tune set up for next week so hopefully it'll be ready to rock.

 

[THAITED]

It should, I'm at 16 psi and almost makes it.

 

[Chances50]

I finally got some numbers, I waited to long and it got hot so boost was only in the 12.5 range but it still made 631rwhp 528rwtq SAE. so im pretty sure with 16-17 high 600's/low 700's is possible.

 

[Lightning&Mach1]

Nice numbers, whats you pulley combo?

 

[Chances50]

stock crank with a 3.125. its seeing 14lbs at 6800 but stops making power at 6300. just flatlines.