Anyone running a v1si 96-98 cobra? E85

[mastercorndog]

looking for what to expect power wise on a stock b head Todd warren specd blower cams 10.5:1 on e85 with a vortech v1si plan on spinning it as far as the blower will go just seeing what people are making with this set up with every bolt on possible and a good built bottom end on corn.

 

[ZeroDCX]

Well considering the SI-Trim flows 50cfm less than a T-Trim, I would also look at T-Trim numbers for comparison as well. That should get you more data to compare. But I'm curious to this as well too.

 

[1996MysticSnake]

Easily over 600 at the wheel. I'm only spinning my v1 T to like 42k. Makes 13lbs in a blow through setup with meth injection.

Car put down 505 on 14 degrees of timing at 6200 rpm.

Didn't spin it any higher and had to pull as much timing as possible because I'm still on the stock bottom end.

Sent from my moto x4 using Tapatalk