I am trying to find a blower to fit my 5.0 swap and that whipple has confirmed that the compressor housing is the same for Termi's and Coyotes, so I know I can get my intake elbow on the passenger side. (If the MAF will bolt up is a question for a later date) I am hoping somebody on here is running one and can get some measurements for me so I can see if it'll clear the firewall.
Can anybody help me out here?
For the 5.0, I think that a measurement from the back of the compressor housing to a relative point on the block would work. Unless somebody has a different idea/method
For the Termi, a measurement from the back of the compressor housing to the firewall, and to the back of the intake elbow.
Can anybody help me out here?
For the 5.0, I think that a measurement from the back of the compressor housing to a relative point on the block would work. Unless somebody has a different idea/method
For the Termi, a measurement from the back of the compressor housing to the firewall, and to the back of the intake elbow.
