Just Ordered the seats from Braum. Can't wait to get the look of Recaros for a 1/3rd of the cost. Quick question. What is the proper way to correct the airbag light. Thanks.
Airbag Resistor
- Thread starter BlackFive.0
- Start date
Just Ordered the seats from Braum. Can't wait to get the look of Recaros for a 1/3rd of the cost. Quick question. What is the proper way to correct the airbag light. Thanks.
Just Ordered the seats from Braum. Can't wait to get the look of Recaros for a 1/3rd of the cost. Quick question. What is the proper way to correct the airbag light. Thanks.
You can buy the Ford airbag resistors part #XF2Z14B022AA....to plug into your existing underseat wire harness. But you will have to cut open the resistors and solder in a 2.2 ohm resistor in place of the existing resistor in the plug, which I think is 7 ohm.
What year car ? You wil need to do the above if it's a 13/14....if it's an 11/12....I think you can just plug in the resistors as is. Couple write ups out there on this....
I'm putting 2010 seats in my 2014 and have run into this issue....still working on it though.
I would definitely get a DMM if you don't already have one and do what this guy did on mustangevolution..
Thread
Thread
I have a 2011
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Users who are viewing this thread
