Air Bag Code 12 Assistance

[DMoto]

I removed the affected MOV (Metal Oxide Varistor), since all is does is clamp voltage/protect other component from electrical surge, and plugged the module back in, replaced the fuse (#4 - 10A), turned on the ignition and it read out Code 52 (Intermittent or Repaired Lost Battery Feed). Which can be cleared by using the diagnostic connector at the base of the glove box. I'm going to replace the MOV and then report back afterwards. But all seems well thus far.

Threads with similar issues:
Air Bag Diagnostic Monitor Commits Suicide - Lincolns OnLine Message Forum
Airbag Diagnostic/Control Module - Ford Truck Enthusiasts Forums



Yes sir. I will post pics shortly. It's not a difficult task, you can access the bolts and remove the module just by pulling back some of the carpeting.


Note: The MOV marked MOV40 is the affected one.

View attachment 594153

View attachment 594154

View attachment 594155

This just happened on my 94 Mustang GT, the light came on flashed a code 12 and the fuse is blown. Can I trouble you to tell me where exactly is the Air Bag Sensor Module, you mentioned you pulled back some carpeting. Thanks

https://www.svtperformance.com/threads/air-bag-code-12-assistance.995056/

 

[ZeroDCX]

Right around the 2:50 minute mark. (Not my video).

Note the is a New Edge model, but it's in the same location for our SN95s.

Good luck.