Aeroforce install

[02JoeGhost]

Getting ready to install my dual setup and need to wire in a fuel psi sensor and oil psi sensor. What is a good 5v source to tap into? Have done some searching and havnt come up with much info. I know aeroforce sells a 5v regulator but I don't want to spend 22 bucks a piece and wait for them. Any info is greatly appreciated.

Joe

 

[Bdubbs]

Tap into the fuse box under steering column. Use a switched 12 volt source. Go to any auto store and pick up a add -a- fuse adapter.

 

[cj428mach]

You're going to need the 5v regulators.

 

[DSG2003Mach1]

I thought I saw you could hook up more than one device to that 5v regulator? itd be worth double checking.

I think the only 5volt power is something in the EGR if a I remember right

 

[cj428mach]

Most engine sensors like maf and tps are 5v but you don't want to hook to them.

 

[whitedevil95]

Aeroforce will read the factory fuel pressuer sensor, why wire in another?

 

[02JoeGhost]

I went full return and want to monitor pressure and not rely on the factory frps. Thanks for thr input mike i will see what i can tap into

 

[whitedevil95]

I went full return and want to monitor pressure and not rely on the factory frps. Thanks for thr input mike i will see what i can tap into

Ah I see. Well for my 3 bar map sensor and when i was using the aeroforce wideband I used add a fuses in the fuse box under the dash to power them.