Ok, so i know this isn't hard. I have a 6 pin male to male firewire cable that i cut one end off. I now have the black, white, green, blue, red, and orange wires. How do I know which wire to connect to the white analog wire that comes from the AEM a/f gauge? I know it is either the orange or the red, but not sure which one. Should I just start datalogging and use trial and error to make sure I tied in the right one?
Also, I've seen two different ways to do this next step. Do I need to 1) ground all correct ground wires or 2) just leave all other wires covered.
Here are links to two different methods:
"How To" datalog AEM wideband with SCT XCAL3 - Lightning Forum | LightningRodder.com
How To: Datalog AEM Uego Wideband
Thanks!
Also, I've seen two different ways to do this next step. Do I need to 1) ground all correct ground wires or 2) just leave all other wires covered.
Here are links to two different methods:
"How To" datalog AEM wideband with SCT XCAL3 - Lightning Forum | LightningRodder.com
How To: Datalog AEM Uego Wideband
Thanks!