Looking to sell my mach 1, its a clean title with 98k miles. Azure blue, 5 speed.
It has a MMR 900 forged teksid shortblock with manley p/r with 0 miles, .20 bored, 9.5 compression, billet hurrican oil pump, windage tray, new water pump with rebuilded heads, 97 cobra intake cams, degreed, multi angle valve job, new timing chain all arp bolts.
Polyurethane engine mounts.
P1SC procharger, red race open bov, 3 core intercooler.
39 cobra injectors, sct 3000 maf, Termi fuel pumps and tank
Aerometer a/f gauge, boost, fuel pressure gauges.
SCT handtuner
New Mac lts with o/x pipe.flowmasters/ rolled tips
Black chrome fr500. 18x9/10
Steeda tri ax short short shifter / steeda quadrant and cable
Spec stage 2 clutch/ billet steel flywheel resurfaced
FRRP pilot and throw out bearing.
Steeda lowering springs.
Lower control arms
The bad has low compression on cylinder 8 i think its a valve since it gets compression. i had problems trying to get it to idle and to start at first, went lean and now wont start. Tires are cracked for sitting for so much time.
It has a MMR 900 forged teksid shortblock with manley p/r with 0 miles, .20 bored, 9.5 compression, billet hurrican oil pump, windage tray, new water pump with rebuilded heads, 97 cobra intake cams, degreed, multi angle valve job, new timing chain all arp bolts.
Polyurethane engine mounts.
P1SC procharger, red race open bov, 3 core intercooler.
39 cobra injectors, sct 3000 maf, Termi fuel pumps and tank
Aerometer a/f gauge, boost, fuel pressure gauges.
SCT handtuner
New Mac lts with o/x pipe.flowmasters/ rolled tips
Black chrome fr500. 18x9/10
Steeda tri ax short short shifter / steeda quadrant and cable
Spec stage 2 clutch/ billet steel flywheel resurfaced
FRRP pilot and throw out bearing.
Steeda lowering springs.
Lower control arms
The bad has low compression on cylinder 8 i think its a valve since it gets compression. i had problems trying to get it to idle and to start at first, went lean and now wont start. Tires are cracked for sitting for so much time.
Last edited:
