This may sound like a dumb question but I don't want to destroy my OEM "A" pillar by pulling on it the wrong way. I'm assuming it snaps on with clips?? If so, which way should I pull on it to remove it? Thanks!
pull it towards you (when sitting in the driver seat) it pulls straight out so dont twist it or pull it much towards the windshield or the drivers door.
its pretty snug but I quick hard pull pops it right out, its just a couple metal pressure pins that are holding it in.
I don't know if you have this or not, but on my vert a pillar there is a small plastic pin at the top that holds the pillar on, so you have top pop that out first. ( If you have it)
Thanks for the info. I don't think I have a "pop top" on my coupe.
I'm not replacing my OEM piece so I don't have a multi-gauge pillar pod to look at the backside to see how its mounted. I'm planning on using a single gauge pod and I want it mounted as low as possible, just above the dashboard. I'll have to live with the fact that it's screwed on.... Thanks again!