A-Pillar gauge pod on my convertible

[Brad]

Just installed the raptor shift light, autometer boost gauge, and water temp gauge. Took weeks of sanding and painting to make this a-pillar fit, but I think it looks damn good. If you want more info on how I made it fit just ask.:-D

 

[slythetove]

Brad,

Do you have the second run A pillar trim that bows out a lot more?

I skimmed your how to on another site, and I think I remember you do.

It looks good man.

 

[Brad]

Originally posted by slythetove
Brad,

Do you have the second run A pillar trim that bows out a lot more?

I skimmed your how to on another site, and I think I remember you do.

It looks good man.

I think I have a second run pillar, it does bow out.

 

[YoungCobra]

Very clean looking install.
Just one question, how did you wire your shift light. It looks very good there but I don't really want to drill any holes in my bezel.

I like the roll bar on the vert too

 

[Brad]

Originally posted by YoungCobra
Very clean looking install.
Just one question, how did you wire your shift light. It looks very good there but I don't really want to drill any holes in my bezel.

I like the roll bar on the vert too

No holes at all, just two sided tape. Only thing is the shift light is not working right for some reason, I made another thread about it. All it does it flashes like mad, not sure I wired it right. Back to mounting the light, just two sided tape and there is a big enough gap where you can thread the wire down behind the dash. Hope that helps:thumbsup:

 

[RDSZ]

Can you please tell me how you hook up the boost gauge coming form the engine. Am trying to do my gauge but dont know where to connect the hose. please help