Just have a few things Id like to get rid of, taken off my car but not necessarily specific to terminators
A very lightly used K&N Air Filter with not kinks/bends, used with a K&N drycharger so it's still very clean and can be used right away, includes clamp. The drycharger has been cleaned, but does have a small cut about 3/8" long on the tapered end. Filter part# RF-1015, measurements are 4" opening, 7" tall/height. This fits the OEM maf(4"opening). Good if you need some extra room and the 9" filter is too long. $50 Shipped+PayPal Fees(cost $100 new)
6" rod of 80a poly tubing to replace the lower caged pulley bushings (there's write ups on SVTP). You can make 2 sets out of this if you're careful. Brand new, $20 shipped+PayPal fees.
Used ARP 8.8 diff carrier bearing cap studs, no damage. $20 shipped+Fees
New summit brand 3" lap joint stainless exhaust band clamps. $20 shipped for the pair. (Cost $10 new each)
A very lightly used K&N Air Filter with not kinks/bends, used with a K&N drycharger so it's still very clean and can be used right away, includes clamp. The drycharger has been cleaned, but does have a small cut about 3/8" long on the tapered end. Filter part# RF-1015, measurements are 4" opening, 7" tall/height. This fits the OEM maf(4"opening). Good if you need some extra room and the 9" filter is too long. $50 Shipped+PayPal Fees(cost $100 new)
6" rod of 80a poly tubing to replace the lower caged pulley bushings (there's write ups on SVTP). You can make 2 sets out of this if you're careful. Brand new, $20 shipped+PayPal fees.
Used ARP 8.8 diff carrier bearing cap studs, no damage. $20 shipped+Fees
New summit brand 3" lap joint stainless exhaust band clamps. $20 shipped for the pair. (Cost $10 new each)
