FS/T; 98 Cobra vert, all forged aluminum Teksid block, ATL $11K
Dyno sheet is NOT a tune. It was just a courtesy run at a meet we had a Kurgans last year. Bob hooked us up with a free run just for giggles.
For sale or trade in ATL, GA. Looking for cars, trucks, motorcycles, guns, other man toys.
Selling mainly to get a more practical family friendly car and another toy at the same time. This is my only vehicle, daily driver.
Real quick with the bad. The body is showing her age and that of a daily driver. Some scratches, nicks, dings, a dent.
AC is not working. I have yet to figure out why. If you feel strongly about it I will get it checked out. I had intended to to the AC delete modification in the future anyway so thats why I have been putting this off. The compressor robs horse power. NEED MORE HORSES.
Approx. 18,xxx trouble free miles on built motor. 121,xxx on the car. This car is young at heart, only showing her age on the exterior. Very fun to drive and I will be very sad to see her go. My blood sweat and tears went into her. All she needs to be prefect is paint and a new top. Nothing wrong with the current one, again just showing its age.
I have all parts receipts except for a few parts that I purchased used from other mustang enthusiasts from online forums. Those parts noted below. Anything marked unknown manufacturer was on the car when I got it. Just about all parts listed where installed at the time the new motor went in.
The motor:
I purchased an all forged built lower from Excessive Motorsports
.020 Over Race Prepped Teksid Block Torque Plate Honed to 3.572" (.020" Over)
ModMax .020" Over CP -9cc Dished Pistons 1.5mm / 1.5mm / 3mm Ring Pack
Manley Forged H-Beam Rods with ARP 2000 Rod Bolt Upgrade
Forged Cobra Crank, Micro Polished Journals
Custom Total Seal Stainless Coated Pistons Rings (Great for Boost/ Nitrous)
Speed Pro Competition Series 3/4 Groove Main Bearings
Speed Pro CH Series Connecting Rod Bearings
ARP 4 Bolt Main Stud Kit for use with factory windage tray
They provided me with the specs on the pistons and rings which is something he told me he doesn't normally share.
I had the cylinder heads reconditioned at a machine shop, and the upper manifold professionally cleaned by them also.
Receipt showing all that they did including hydro test- pressure testcooling system / water jacket. Disassemble clean and machine valves and valve seats, set valve height and spring pressure.
New lifters
Completely new engine gasket set. New gaskets through out.
Dynagear timing set.
crank shaft gear
MMR racing/street oil pump (high volume) w/ cryo gearset.
15/16 oil pick up tube
Oil pan. No receipt but purchased new from an ebay seller.
Accufab billet trigger wheel
EMP high performance water pump
Hypertech 180* thermostat
New Ford oil cooler and gaskets
Ford Motorcraft EGR valve
EGR valve gasket
IAC valve
Crankshaft position sensor
Temperature sensor
Air bypass valve
Knock sensor
ARP cam bolts
310 LPH Ford returnless fuel pump. Larger than stock so if you go forced induction, you are covered here. Just upgrade fuel lines maybe and of course injectors.
Fuel filter
2003 cobra radiator. No receipt
New battery and connectors.
BBK cold air intake. No receipt, purchased used.
All new spark plugs
MSD ignition coils and wires. Was on the car when I purchased
New alternator
Steeda X-pipe with high flow cats. Was on the car when I purchased
Steeda Loud Mouth 2 exhaust. Was on the car when I purchased
resurfaced flywheel
Steering, suspension, brakes and wheels:
Team Z, K member installed May 22, 2013
Team Z non-adjustable A-Arms installed May 22, 2013
Griggs front coil-overs and springs. Was on the car when I purchased
Griggs bumpsteer kit. Was on the car when I purchased
Griggs caster camber plates. Was on the car when I purchased
KYB 8 way adjustable rear shocks. Purchased lightly used.
BBK rear springs. Was on the car when I purchased
2003 cobra steering rack. No receipt, purchased like new.
2003 cobra steering column.
1" wheel spacers in the rear.
Drilled and slotted rotors front and rear, unk manf. Was on the car when I purchased
Steel braided brake lines unk manf. Was on the car when I purchased
New Hawk ceramic brake pads up front.
Steed Ultralite chrome wheels 18x? either 9 or 9.5 all around. These were on the car when I bought it so I'm not sure.
Pirelli Pzero Nero 255/35 front, 4-5 32nds left
Pirelli Pzero Nero 265/35 rear, 7-8 32nds left
Exterior:
Depo headlights
Depo clear diamond side markers with amber reflector
All new headlight adjusters and pivots
Raxiom smoked taillights
black LED third brake light
New header panel
Here's the "bad"
Previously had an ugly body kit with some damage so I aquired used front bumber cover, rear bumper cover, and side skirts. They were not as described by the seller. Several scratches and nicks. I kinda got burned on that deal but it is not so terrible as the rest of the car has a few scratches and dents. She does show her age when it comes to the exterior. The body kit previously installed had door panels. These are still on the doors because I am afraid of the damage it may cause to the paint when removed. I don't know if they were installed with double sided tape which would be the best case scenario leaving minimal evidence, or if liquid nails was used which will most likely destroy the paint when removed. So they are still installed, luckily it really doesn't stand out that much, or look bad. Top is kinda faded. Cracking in a few spots around edge.
Interior:
Stock. All black leather.
Stock Mach stereo sound system.
Cool white LEDs installed in dash. Appear blue.
Steeda adj. shifter w/ unk. shifter knob. Was on the car when I purchased
FR500 steering wheel. Was on the car when I purchased
Price: $11,000 Reduced to $10,500
What I am looking for as far as vehicle trade MUST be a running daily driver. List of what I am most interested in at the moment followed by a list of general interests.
Most highly interested in:
Toyota Tacoma crew cab
2004 Mercury Marauder
07'-Harley Davidson Dyna Street Bob
07'-Harley Davidson Dyna models
Generally interested in:
All other crew cab, quad can, ext. cab pick up trucks
SUVs
Four door sedans only, nothing 2 door.
Motorcycles must be clean and running. No projects, no antiques.
Harley Davidson motorcycle.
Harley Davidson Nightster
2007 - 2008 Roaster 1200R
xr1200
XL1200X 48
Cruiser, sport bike, dirt bike, dual sport
Triumph, Yamaha, Honda
BMW F800GS or R1200GS
Guns, ammo, gear, armor
$GONE
Dyno sheet is NOT a tune. It was just a courtesy run at a meet we had a Kurgans last year. Bob hooked us up with a free run just for giggles.
For sale or trade in ATL, GA. Looking for cars, trucks, motorcycles, guns, other man toys.
Selling mainly to get a more practical family friendly car and another toy at the same time. This is my only vehicle, daily driver.
Real quick with the bad. The body is showing her age and that of a daily driver. Some scratches, nicks, dings, a dent.
AC is not working. I have yet to figure out why. If you feel strongly about it I will get it checked out. I had intended to to the AC delete modification in the future anyway so thats why I have been putting this off. The compressor robs horse power. NEED MORE HORSES.
Approx. 18,xxx trouble free miles on built motor. 121,xxx on the car. This car is young at heart, only showing her age on the exterior. Very fun to drive and I will be very sad to see her go. My blood sweat and tears went into her. All she needs to be prefect is paint and a new top. Nothing wrong with the current one, again just showing its age.
I have all parts receipts except for a few parts that I purchased used from other mustang enthusiasts from online forums. Those parts noted below. Anything marked unknown manufacturer was on the car when I got it. Just about all parts listed where installed at the time the new motor went in.
The motor:
I purchased an all forged built lower from Excessive Motorsports
.020 Over Race Prepped Teksid Block Torque Plate Honed to 3.572" (.020" Over)
ModMax .020" Over CP -9cc Dished Pistons 1.5mm / 1.5mm / 3mm Ring Pack
Manley Forged H-Beam Rods with ARP 2000 Rod Bolt Upgrade
Forged Cobra Crank, Micro Polished Journals
Custom Total Seal Stainless Coated Pistons Rings (Great for Boost/ Nitrous)
Speed Pro Competition Series 3/4 Groove Main Bearings
Speed Pro CH Series Connecting Rod Bearings
ARP 4 Bolt Main Stud Kit for use with factory windage tray
They provided me with the specs on the pistons and rings which is something he told me he doesn't normally share.
I had the cylinder heads reconditioned at a machine shop, and the upper manifold professionally cleaned by them also.
Receipt showing all that they did including hydro test- pressure testcooling system / water jacket. Disassemble clean and machine valves and valve seats, set valve height and spring pressure.
New lifters
Completely new engine gasket set. New gaskets through out.
Dynagear timing set.
crank shaft gear
MMR racing/street oil pump (high volume) w/ cryo gearset.
15/16 oil pick up tube
Oil pan. No receipt but purchased new from an ebay seller.
Accufab billet trigger wheel
EMP high performance water pump
Hypertech 180* thermostat
New Ford oil cooler and gaskets
Ford Motorcraft EGR valve
EGR valve gasket
IAC valve
Crankshaft position sensor
Temperature sensor
Air bypass valve
Knock sensor
ARP cam bolts
310 LPH Ford returnless fuel pump. Larger than stock so if you go forced induction, you are covered here. Just upgrade fuel lines maybe and of course injectors.
Fuel filter
2003 cobra radiator. No receipt
New battery and connectors.
BBK cold air intake. No receipt, purchased used.
All new spark plugs
MSD ignition coils and wires. Was on the car when I purchased
New alternator
Steeda X-pipe with high flow cats. Was on the car when I purchased
Steeda Loud Mouth 2 exhaust. Was on the car when I purchased
resurfaced flywheel
Steering, suspension, brakes and wheels:
Team Z, K member installed May 22, 2013
Team Z non-adjustable A-Arms installed May 22, 2013
Griggs front coil-overs and springs. Was on the car when I purchased
Griggs bumpsteer kit. Was on the car when I purchased
Griggs caster camber plates. Was on the car when I purchased
KYB 8 way adjustable rear shocks. Purchased lightly used.
BBK rear springs. Was on the car when I purchased
2003 cobra steering rack. No receipt, purchased like new.
2003 cobra steering column.
1" wheel spacers in the rear.
Drilled and slotted rotors front and rear, unk manf. Was on the car when I purchased
Steel braided brake lines unk manf. Was on the car when I purchased
New Hawk ceramic brake pads up front.
Steed Ultralite chrome wheels 18x? either 9 or 9.5 all around. These were on the car when I bought it so I'm not sure.
Pirelli Pzero Nero 255/35 front, 4-5 32nds left
Pirelli Pzero Nero 265/35 rear, 7-8 32nds left
Exterior:
Depo headlights
Depo clear diamond side markers with amber reflector
All new headlight adjusters and pivots
Raxiom smoked taillights
black LED third brake light
New header panel
Here's the "bad"
Previously had an ugly body kit with some damage so I aquired used front bumber cover, rear bumper cover, and side skirts. They were not as described by the seller. Several scratches and nicks. I kinda got burned on that deal but it is not so terrible as the rest of the car has a few scratches and dents. She does show her age when it comes to the exterior. The body kit previously installed had door panels. These are still on the doors because I am afraid of the damage it may cause to the paint when removed. I don't know if they were installed with double sided tape which would be the best case scenario leaving minimal evidence, or if liquid nails was used which will most likely destroy the paint when removed. So they are still installed, luckily it really doesn't stand out that much, or look bad. Top is kinda faded. Cracking in a few spots around edge.
Interior:
Stock. All black leather.
Stock Mach stereo sound system.
Cool white LEDs installed in dash. Appear blue.
Steeda adj. shifter w/ unk. shifter knob. Was on the car when I purchased
FR500 steering wheel. Was on the car when I purchased
Price: $11,000 Reduced to $10,500
What I am looking for as far as vehicle trade MUST be a running daily driver. List of what I am most interested in at the moment followed by a list of general interests.
Most highly interested in:
Toyota Tacoma crew cab
2004 Mercury Marauder
07'-Harley Davidson Dyna Street Bob
07'-Harley Davidson Dyna models
Generally interested in:
All other crew cab, quad can, ext. cab pick up trucks
SUVs
Four door sedans only, nothing 2 door.
Motorcycles must be clean and running. No projects, no antiques.
Harley Davidson motorcycle.
Harley Davidson Nightster
2007 - 2008 Roaster 1200R
xr1200
XL1200X 48
Cruiser, sport bike, dirt bike, dual sport
Triumph, Yamaha, Honda
BMW F800GS or R1200GS
Guns, ammo, gear, armor
Last edited:
