1995 Mustang GT
331 Stroker short block, all forged internals, purchased new in 2009
Edelbrock E-Street Heads with Harland Sharp roller rocker arms
Lanati Voodoo camshaft
Trick Flow Track Heat upper, lower intake manifold w/ ½ inch spacer
75mm Professional Products throttle body with Trick Flow Elbow
75mm Pro-M mass-air sensor calibrated for 24lb injectors
BBK fenderwell cold air induction
Smog pump delete pulley
24 lb injectors with Walbro 255lph fuel pump
Suspension
MM K-Member
MM front and rear control arms
BBK rear upper control arms
MM panhard bar
MM caster/camber plates
Tokico D-Spec adjustable shocks and struts (coil-overs in front)
Saleen RaceCraft springs in back
Eibach rear sway-bar
MM solid steering rack bushings
MM adjustable tie-rod ends
MM solid steering shaft
Drivetrain
Ram clutch
World Class T-5 manual transmission
MGW shifter
Aluminum drive shaft
8.8 rear end with 3:73 gears
18 inch Steeda Ultralite wheels with good tires all around
Exhaust
BBK ceramic long-tube headers
BBK 2.5 inch H-pipe (catless)
Flowmaster single chamber mufflers
Stock dia exhaust after H-pipe due to panhard bar clearance tolerances
Chip
4 bank BAMA performance chip
SCT tuned by Tim Matherly at MV Performance
Bank 0: stock tune
Bank 1: street tune
Bank 2: hot street tune
Bank 3: race tune (for use with race gas)
Misc.
One piece headlights
A/C service, new battery, new TPS, and tune all in March 2012
New water pump and A/C compressor in November 2011
I have a pair of MM full length, weld-in subframe connectors that will come with the car
333hp, 351tq at rear wheels on Mustang Dyno
All work done by myself and a friend, both ASE certified
Contact info
Call or text (802) 338-7930
CAR IS LOCATED IN CARNESVILLE, GA. NOT VERMONT.
Try to refrain from posting to contact me as i only have internet access a few times a week.
Asking $6000
Title in hand
I have a bunch of other misc. mustang parts if interested
Issues
A tear in the left driver's seat bolster
Speedo reads high
Paint shines up pretty good aside from slightly faded rear bumper and highway chippage on front bumper. A few other blemishes as well. Shows it'.s age
Drivers side fog light bracket broken. Light still works but is not in correct place
Previous owner installed an aftermarket head unit but not the appropriate adapter harness so the Mach 460 amps are not active
Has an erratic idle issue that is not tune-related. Thought it was fixed but then it came back, can't figure it out.
331 Stroker short block, all forged internals, purchased new in 2009
Edelbrock E-Street Heads with Harland Sharp roller rocker arms
Lanati Voodoo camshaft
Trick Flow Track Heat upper, lower intake manifold w/ ½ inch spacer
75mm Professional Products throttle body with Trick Flow Elbow
75mm Pro-M mass-air sensor calibrated for 24lb injectors
BBK fenderwell cold air induction
Smog pump delete pulley
24 lb injectors with Walbro 255lph fuel pump
Suspension
MM K-Member
MM front and rear control arms
BBK rear upper control arms
MM panhard bar
MM caster/camber plates
Tokico D-Spec adjustable shocks and struts (coil-overs in front)
Saleen RaceCraft springs in back
Eibach rear sway-bar
MM solid steering rack bushings
MM adjustable tie-rod ends
MM solid steering shaft
Drivetrain
Ram clutch
World Class T-5 manual transmission
MGW shifter
Aluminum drive shaft
8.8 rear end with 3:73 gears
18 inch Steeda Ultralite wheels with good tires all around
Exhaust
BBK ceramic long-tube headers
BBK 2.5 inch H-pipe (catless)
Flowmaster single chamber mufflers
Stock dia exhaust after H-pipe due to panhard bar clearance tolerances
Chip
4 bank BAMA performance chip
SCT tuned by Tim Matherly at MV Performance
Bank 0: stock tune
Bank 1: street tune
Bank 2: hot street tune
Bank 3: race tune (for use with race gas)
Misc.
One piece headlights
A/C service, new battery, new TPS, and tune all in March 2012
New water pump and A/C compressor in November 2011
I have a pair of MM full length, weld-in subframe connectors that will come with the car
333hp, 351tq at rear wheels on Mustang Dyno
All work done by myself and a friend, both ASE certified
Contact info
Call or text (802) 338-7930
CAR IS LOCATED IN CARNESVILLE, GA. NOT VERMONT.
Try to refrain from posting to contact me as i only have internet access a few times a week.
Asking $6000
Title in hand
I have a bunch of other misc. mustang parts if interested
Issues
A tear in the left driver's seat bolster
Speedo reads high
Paint shines up pretty good aside from slightly faded rear bumper and highway chippage on front bumper. A few other blemishes as well. Shows it'.s age
Drivers side fog light bracket broken. Light still works but is not in correct place
Previous owner installed an aftermarket head unit but not the appropriate adapter harness so the Mach 460 amps are not active
Has an erratic idle issue that is not tune-related. Thought it was fixed but then it came back, can't figure it out.
Last edited: