87 Coupe Roller with SN95 Interior swap and other goodies

IndiaHatCobra

Member
Established Member
Joined
Jan 13, 2005
Messages
438
Location
San Diego
New lower price - 1400 as a 4 lug roller, no seats

Good:
Clean title in hand, all dues paid, non-op
90% of the hard work done for a mod swap. Fuel lines, gas tank, brake lines, 96 Cobra rearend, rear slotted rotors, lowering springs, Polished 03 Cobra 17's with 75% tires (can probobly go back to a 5.0, just have to swap computer harness and engine wiring)
Full dash swap with cobra cluster, center console, carpet, near mint leather seats, (rear seats were put in with an extra brace under them to fit the SN carpet, not cheesy with a gap like some people do it)
All wiring done on inside, and to engine bay with Cobra computer
Hydroboost, lines, rack ect and extra parts
T45 crossmember mocked and bracket welded in
mach 460 system sitting in the back
non power windows and mirrors
bumpers are good and wont need to be replaced
have 2 sets of door panels for it now as well
98 K member and 5 lug spindles up front

The bad:
Was painted white (orig blue) and it needs to be done again, still very drivable,
Dings in a few spots and the worst being the corner pictured
needs a new deck lid as the one on it was shaved for some reason and no way to lock it
Driver side airbag is out of a T bird, and passenger has slit in it
dash has a crack, not bad but there
needs headliner
and of course a motor



any other offers for a lower price on the whole car and taking stuff out, im all ears. Will also take partial trade if your close or want to ship or however. looking for a cheap V8 truck, cheap quad (adult), stalker front bumper, aluminum driveshaft, D/S rotors for 94-98, good adjustable struts (to fit coilovers), Trickflow or GT40 tubular intake, 70mm polished or chrome tb/spacer, aluminum heads, Mint opal grey interior (everthing but dash, seats and seat belts)


006-7.gif

007-9.gif

009-2.gif

008-4.gif
 
Last edited by a moderator:

stackett

GM KILLER
Established Member
Joined
May 7, 2010
Messages
16
Location
ohio
how much just for the seats? How do you plan to open the doors with the sn-95 dash handles are pretty much covered,where did you get the seats some of the niciest i ve ever seen need them for my cobra
 

IndiaHatCobra

Member
Established Member
Joined
Jan 13, 2005
Messages
438
Location
San Diego
I can throw in a T45 Trans, bassani Catted X pipe, 4.6 iron short block w/ tons of extra parts, almost complete, also 4v heads and everything to do a 4v head swap minus the cams, extra crank, pistons, clutch, flywheel ect ect for full asking price
 

Users who are viewing this thread



Top