***All items SOLD***
Complete cj428mach 4lb lower pulley kit including Billet Pro Shop idler, 4lb lower pulley, locking hub, factory bracket and tri bar assembly. This kit comes disassembled and will need to be properly assembled by new owner (tri bar drilled and clocked etc etc). The 4lb kit is all brand new. The stock lower bracket parts have around 70k miles on them and have been freshly powdercoated. Sold
Reichard Racing 2.65 upper pulley for Eaton, like new, very low miles. This is the smallest pulley you can run without having to machine the snout of the blower and they're not in production anymore. Sold
SCT BA3000 mass air flow sensor with housing. Housing probably needs to be cleaned a little bit but looks to be in great shape. I never got to run it. Sold
Two like new aftermarket (UPR?) double bearing 90mm idlers. Ran one time on initial start up on new engine, the bearings in both failed and flung grease and junk everywhere. Company would warranty them but I had to pay shipping which was BS to me so I never did anything with them. They will both need new bearings pressed in. Sold for both
Cobra painted mirrors. Paint in great shape except for a couple small scratches on passenger mirror, some jerk off had keyed the previous owners entire car including that mirror. The scratches are noticeable enough to make me want to get them repainted... Sold
Stock Cobra driveshaft yoke, unknown miles, good shape Make offer
New edge mustang car cover, has tri bar pony emblem on front, fits great. Has elastic along front and rear lower edges. Has a few very small holes in it, one of them was poked through for the antenna. Has grommets along the bottom edge to tie down the edges and keep it from blowing off if desired. Sold
Thanks for looking
Matt
Complete cj428mach 4lb lower pulley kit including Billet Pro Shop idler, 4lb lower pulley, locking hub, factory bracket and tri bar assembly. This kit comes disassembled and will need to be properly assembled by new owner (tri bar drilled and clocked etc etc). The 4lb kit is all brand new. The stock lower bracket parts have around 70k miles on them and have been freshly powdercoated. Sold
Reichard Racing 2.65 upper pulley for Eaton, like new, very low miles. This is the smallest pulley you can run without having to machine the snout of the blower and they're not in production anymore. Sold
SCT BA3000 mass air flow sensor with housing. Housing probably needs to be cleaned a little bit but looks to be in great shape. I never got to run it. Sold
Two like new aftermarket (UPR?) double bearing 90mm idlers. Ran one time on initial start up on new engine, the bearings in both failed and flung grease and junk everywhere. Company would warranty them but I had to pay shipping which was BS to me so I never did anything with them. They will both need new bearings pressed in. Sold for both
Cobra painted mirrors. Paint in great shape except for a couple small scratches on passenger mirror, some jerk off had keyed the previous owners entire car including that mirror. The scratches are noticeable enough to make me want to get them repainted... Sold
Stock Cobra driveshaft yoke, unknown miles, good shape Make offer
New edge mustang car cover, has tri bar pony emblem on front, fits great. Has elastic along front and rear lower edges. Has a few very small holes in it, one of them was poked through for the antenna. Has grommets along the bottom edge to tie down the edges and keep it from blowing off if desired. Sold
Thanks for looking
Matt
Last edited: