Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Cobra Forums
New Edge Cobras
3650 input shaft bearing how to?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="thebestdj07" data-source="post: 10865135" data-attributes="member: 97417"><p>if its the outer one just remove bell housing and use a bearing splitter to pull it off. heat the new one up and give it a few taps to seat it on. </p><p></p><p>if you want to get to the inners then tear it down per the service manual. basicaly take off the tail housing. remove everything on the counter shaft, remove the shifter linkage, take off the hold down on the shift fork rods, there are 3 pins in there you must remove also., then unbolt the bell housing and set it on the bell with a block of wood under each side to keep it up off the inputshaft, then remove the main case, just yank up on it hard a few times there is a bearing on the counter shaft. remove your shift forks and pull the main shaft up and out, then you can get to the input shaft inner bearings. its all in the service manual with pretty pictures :rockon:</p></blockquote><p></p>
[QUOTE="thebestdj07, post: 10865135, member: 97417"] if its the outer one just remove bell housing and use a bearing splitter to pull it off. heat the new one up and give it a few taps to seat it on. if you want to get to the inners then tear it down per the service manual. basicaly take off the tail housing. remove everything on the counter shaft, remove the shifter linkage, take off the hold down on the shift fork rods, there are 3 pins in there you must remove also., then unbolt the bell housing and set it on the bell with a block of wood under each side to keep it up off the inputshaft, then remove the main case, just yank up on it hard a few times there is a bearing on the counter shaft. remove your shift forks and pull the main shaft up and out, then you can get to the input shaft inner bearings. its all in the service manual with pretty pictures :rockon: [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cobra Forums
New Edge Cobras
3650 input shaft bearing how to?
Top