3 bolt Kooks Header Flange

[Quicktime_GT]

Anyone seen this before? I have a set of Kooks / JDM hybrid headers.

Looking for an X Pipe that will work, but had rather not run a JDM. Any input?

 

[JuStAkId]

That is how my kooks long tubes are. What exactly are you asking? A midpipe that would fit that?

you will have to modify a little
Any x pipe should fit I think.
You just will have to replace the ball and socket with 3 bolt flange

That for the 3 bolt flange (cut off existing ball and socket flange)
http://www.ebay.com/itm/Summit-Raci...-3-Outlet-3-Bolt-Flange-G4752ID-/111167468077

3'' for cb
Kooks 96-04 Mustang 3" Inlet w/3" Outlet Offroad XPipe
2.5'' for cb
Kooks 96-04 Mustang 3" Inlet w/3" Tubing 2.5" Outlet Offroad XPipe

Keep in mind you can get them with cats if need be.
Kooks Custom Headers 6016 Kooks Ford Off-Road Midpipes

All depends on the size of your catback as well

Here are a few pictures of mine (previous owner fab'd it up)
My cats are hollowed out by the way because one went bad

Hope this helps

 

[Quicktime_GT]

Thank You!

My catback is a 2.5" borla stinger setup, so I had planned to run a 2.5" X Pipe as well.

For whatever reason I just cringe at the idea of giving $400 for an X pipe..

 

[JuStAkId]

Thank You!

My catback is a 2.5" borla stinger setup, so I had planned to run a 2.5" X Pipe as well.

For whatever reason I just cringe at the idea of giving $400 for an X pipe..

you should be able to buy whatever and just put the 3 bolt flange on it.
The ones I listed are just kooks.