2011 Ford MPH based boost

4DRHTRD

Ecoboosted!!!!
Established Member
Joined
Nov 5, 2012
Messages
84
Location
Phoenix
I'm continuing to work on my Flex and as we've been going through tune revisions and I have more power my first gear boost level has become an issue. You can't boost per gear in the ecoboost and I can no longer give any boost load up in first to take off and 70% of the time even with going from idle I still end up with the ECU closing the throttle due to too much wheel spin and torque sent to the rear axle. This will only get worse when I install my new turbos next week so I'm looking for a way to reduce boost in first gear.
My thought is to introduce a boost controller that works on MPH so that I can reduce boost in 1st gear and mitigate these issues. In a GM car you just grab VSS and you're good. In a Ford it's OSS and other than that I am unfamiliar with the Ford platforms inner workings of that signal.

Does anybody know of an OSS MPH switch or a how to convert OSS to VSS or a boost controller that will work with Ford OSS signal?

I've been doing quite a bit of searching but I'm probably not looking right.
Thanks!
 

Users who are viewing this thread



Top