50racer
New Member
Put car back to stock. I have a complete mid mount (same place as lpf and hellion sleeper) twin turbo kit with Precision T59 Turbos (5976E). 2 Tail 38mm Wastegates (all springs), RB Racing Scavenge Pump, Intercooler, headers, oil lines, new vacuum line, air filters, and plumbing.
I am including the pipes from the downpipes to the stock catback 3" location. I am also including the 90 degree billet oil drain line adapters. Also the RB Racing scavenge pump didn't originally come with the kit. The one the kit came with sucked so i got this one. Those 3 items alone were about $700.
Built by boostworks (yes it took forever to get it ) I have had it on the car for about a year and about 700 miles. Note that the throttle body to blowoff pipe may have to be cut and rewelded depending on your intake. it was made for a stock based intake manifold which positions the throttle body facing up. i had a holley intake and the tb faces down so i had to cut the pipe in half and rewelded shifted 45 degrees to make it face up to match TB. if i had a nice elbow it could have fit, but why do that. it cost $20 to have it welded where i wanted it. If you look at the top picture the big 4" pipe s shaped with the place to put the MAF sensor you can see the weld above it. Looking for $5200 obo. Email or text me at 954-465-7146. Thanks for your time
I am including the pipes from the downpipes to the stock catback 3" location. I am also including the 90 degree billet oil drain line adapters. Also the RB Racing scavenge pump didn't originally come with the kit. The one the kit came with sucked so i got this one. Those 3 items alone were about $700.
Built by boostworks (yes it took forever to get it ) I have had it on the car for about a year and about 700 miles. Note that the throttle body to blowoff pipe may have to be cut and rewelded depending on your intake. it was made for a stock based intake manifold which positions the throttle body facing up. i had a holley intake and the tb faces down so i had to cut the pipe in half and rewelded shifted 45 degrees to make it face up to match TB. if i had a nice elbow it could have fit, but why do that. it cost $20 to have it welded where i wanted it. If you look at the top picture the big 4" pipe s shaped with the place to put the MAF sensor you can see the weld above it. Looking for $5200 obo. Email or text me at 954-465-7146. Thanks for your time