Ok guys i will get a TVS 13-14 shelby and i will like to see some dyno sheets if u guys can share thanks 
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
13-14 TVS swap dyno sheets?
- Thread starter Nestor_GT500
- Start date
frpp resonator delete and filter
stock throttle body
56lb
lethal off road x
pypes axleback
loaded dyno, std, superflow dynojet conversion was in the 635rwnp range. I don't think the torque was as high on the second and third pull.
stock throttle body
56lb
lethal off road x
pypes axleback
loaded dyno, std, superflow dynojet conversion was in the 635rwnp range. I don't think the torque was as high on the second and third pull.
frpp resonator delete and filter
stock throttle body
56lb
lethal off road x
pypes axleback
loaded dyno, std, superflow dynojet conversion was in the 635rwnp range. I don't think the torque was as high on the second and third pull.
nice no pulleys ?
Sent from my iPhone using Tapatalk
stock pulley for the tvs
vmp tune
steeda intakefrpp resonator delete and filter
stock throttle body
56lb
lethal off road x
pypes axleback
loaded dyno, std, superflow dynojet conversion was in the 635rwnp range. I don't think the torque was as high on the second and third pull.
2.60 steeda upper pulley
15% lower pulley
Big Front Mouth
JBA LongTubes
JBA X pipe
VMP BAP dual boost pumps
stock piping with flowmaster Axle back
4.10 gears
Aluminium drive shaft
posi race differential
2013 clutch and injectors=56lbs
Tuned by Ken
this are my mods i will b adding the TVS 13-14
Sent from my iPhone using Tapatalk
u need to top that off with a throttle body
wait - perhaps - Big front mouth is a throttle body ? If so, you are golden for +700hp but i would think about bigger injectors with that setup.
yes i will get a eleptical big bore TB and a 148 mm intake
Sent from my iPhone using Tapatalk
big front mouth is big intercoler yes i wil get id 1000 but ima use my 13 injectores 56lbs for now and i have a VMP BAP
Sent from my iPhone using Tapatalk
Users who are viewing this thread
