Moving in 3 weeks and I will no longer have a garage. I just recently swapped a 04 Mach 1 engine into the car and ran out of money to be able to tune it. The car runs great, pulls hard but being my daily and untuned I do not rag on it since I don't want to break it. Only problems I've run into with the swap was the passenger side valve cover tube seals are leaking slightly, The 2 fronts. I have owned this car for over 3 years and have done a ton to get it back to where it should be, I'm just currently tapped out with affording it.
Mods/specs:
2004 Mach 1 swap. 46,xxx on the block, heads, rotating assembly ect.
2003 terminator valve covers (painted wrinkle black)
2001 cobra upper intake hat, 2004 Mach 1 lower intake.
New intake gaskets.
New idle air control.
Painted wrinkle black coil covers.
The red monster COP swap.
8 new motorcraft coils.
8 new motorcraft spark plugs.
New rear main seal.
Mach 1 throttle cable. (Cruise cable isn't there)
New spec 11in alum flywheel.
Front bumper cover painted to match 1 month ago.
Parts that the car already had:
Bassani x pipe and mufflers.
Terminator interior. (Light suede)
American muscle fr500 (18x9/10 with 275/295 tires)
FRPP 4.10s, Yukon axles.
Eibach pro kit no ISO.
American muscle smoked headlights.
Pro 5.0 shifter with steeda handle.
Full length subframes welded in.
HID/LED lighting (gauges, headlights, fog lights, license plate and done lights)
I'm sure there's a lot I'm forgetting. The car currently has 123,XXX miles, engine 46,XXX, rear end 11,XXX and transmission 11,XXX. It pulls hard as hell with the c heads for the few times I've gotten into it. The car needs a tune for obvious reasons (imrc codes, smog codes and knock sensor codes) since the car has none of that. I just cannot afford a tune at the moment. The car is located in south Florida. I'm willing to possibly trade for something else so don't be afraid to offer. The car does need a few small things and the paint is sorta faded in spots but the body is straight.
$9,500 Obo.
Mods/specs:
2004 Mach 1 swap. 46,xxx on the block, heads, rotating assembly ect.
2003 terminator valve covers (painted wrinkle black)
2001 cobra upper intake hat, 2004 Mach 1 lower intake.
New intake gaskets.
New idle air control.
Painted wrinkle black coil covers.
The red monster COP swap.
8 new motorcraft coils.
8 new motorcraft spark plugs.
New rear main seal.
Mach 1 throttle cable. (Cruise cable isn't there)
New spec 11in alum flywheel.
Front bumper cover painted to match 1 month ago.
Parts that the car already had:
Bassani x pipe and mufflers.
Terminator interior. (Light suede)
American muscle fr500 (18x9/10 with 275/295 tires)
FRPP 4.10s, Yukon axles.
Eibach pro kit no ISO.
American muscle smoked headlights.
Pro 5.0 shifter with steeda handle.
Full length subframes welded in.
HID/LED lighting (gauges, headlights, fog lights, license plate and done lights)
I'm sure there's a lot I'm forgetting. The car currently has 123,XXX miles, engine 46,XXX, rear end 11,XXX and transmission 11,XXX. It pulls hard as hell with the c heads for the few times I've gotten into it. The car needs a tune for obvious reasons (imrc codes, smog codes and knock sensor codes) since the car has none of that. I just cannot afford a tune at the moment. The car is located in south Florida. I'm willing to possibly trade for something else so don't be afraid to offer. The car does need a few small things and the paint is sorta faded in spots but the body is straight.
$9,500 Obo.