SOLD!
She's not a show car by any means, paint has dings and chips in it, driver's door has been replaced and there are a couple of scratches in both doors. She's a driver, not a show car. Just over 100k miles located in Huntsville, Alabama. List of mods includes:
Bassani Mid Length Headers
Bassani O/R X-pipe
Jardine Axle back
MM Delrin Rear Control arm bushings
MM Poly IRS bushings and Low profile bolts
MM Rear tie rods
FRPP 3.73:1 Gears
G-Force 1000HP half shafts
MM Strut Tower Brace
MM K-member brace
MM C/C Plates
MM Full-length Subframe connectors (welded in)
JLT Cold Air
MGW Shift with Race and Sport Handles
Cobra R 4 piston Brembo Calipers
Slotted rotors and Hawks pads and SS brake lines on all four corners
H&R Race springs
SCT X-4 tuner
Included with the car but not installed are a BilletFlow 2.7 pulley with hub, 100mm snub idler, Fore fuel hat with twin GT pumps, Dual FPDM setup, and a welded and ported intake plenum. I also have a ported blower that needs to be assembled that I will throw in if you want it. I have the complete rebuild kit for it, just don't have the motivation to finish it.
She's not a show car by any means, paint has dings and chips in it, driver's door has been replaced and there are a couple of scratches in both doors. She's a driver, not a show car. Just over 100k miles located in Huntsville, Alabama. List of mods includes:
Bassani Mid Length Headers
Bassani O/R X-pipe
Jardine Axle back
MM Delrin Rear Control arm bushings
MM Poly IRS bushings and Low profile bolts
MM Rear tie rods
FRPP 3.73:1 Gears
G-Force 1000HP half shafts
MM Strut Tower Brace
MM K-member brace
MM C/C Plates
MM Full-length Subframe connectors (welded in)
JLT Cold Air
MGW Shift with Race and Sport Handles
Cobra R 4 piston Brembo Calipers
Slotted rotors and Hawks pads and SS brake lines on all four corners
H&R Race springs
SCT X-4 tuner
Included with the car but not installed are a BilletFlow 2.7 pulley with hub, 100mm snub idler, Fore fuel hat with twin GT pumps, Dual FPDM setup, and a welded and ported intake plenum. I also have a ported blower that needs to be assembled that I will throw in if you want it. I have the complete rebuild kit for it, just don't have the motivation to finish it.
Last edited:
