Meant to post this in this forum and posted in the the other gt500 forum.
Maybe you guys can help me out. I can not find a MPSS 105Y in a 295/35/20 anywhere in any flavor. Any alternate suggestions besides the 285?
Black and bone stock. Never pullied, raced, and always garage kept. Dyno'd one time 375/355. Have original buyers paper work and SVT Cert.
New Bilstiens and H&R Race springs, MM full length sub-frames, MM end links and sway bar bushings, MM low profile IRS bolt, MM triple chrome CC plates, and...
I had some H&R springs installed with new bilsteins. I drove in home from the install and it was good. I drove the car again, my drive way has a small curb maybe 1 inch or so, so I easied off the drive way and drove it to the store.
Now I have a noise everytime I hit a small bump. It sounds...
They have locations in Weatherford and Granbury. They do tinting, car audio, and truck accessories.
Stay away..
I called last friday to set an appointment to get my windows tinted today. The guy said it would be $79.00 and we were set to go.
I get there on time, and they ask me if I could...
I'm going to order the 17x10.5 27mm offset replicas and putting a 315 tire on them. I will have H&R Race Springs with the low profile IRS bolt.
#1 Will I need a spacer?
#2 Going with this set-up will I need to roll the fenders? (I hope not) if so, how does a 295 look on the 10.5s?
Thanks
I know quite a few guys here swear by HPP. I'm going to be dropping quite a bit of money with them over the next several months, but it will be done in stages. So I have a few questions.
Customer involvement? Let you be involved, to a point, regarding installation and tuning?
Information, do...
My planned set-up (currently my 04 is bone stock):
K&N air filter or JLT RAI
Mid pipe w/cats
Cat Back
Stage IV Steigmeir Ported Eaton Blower
2.76 Billet Flow Pulley
SCT MAF 2400 90MM
Ford GT Pump and Modified FPDM Upgrade Kit PPRV Delete
Idler Pullies and Tensioner
SCT...