Search results

as the title says I’m looking for tailpipes and tips for my catback. Let me know what you have!

https://www.flickr.com/photos/42495203@N03/35904530875/in/dateposted-public Happened to see this 2018 GT outside of my job this morning. I didn't think these cars were out yet and it had Michigan plates. Sounded and looked awesome!

Hey guys, what tailpipes is everyone running on their IRS swapped SN95s? So far I've gathered the following: SLPs look perfect Magnaflow tends to be angled down. I installed a Borla touring catback and it again looks angled down. If i put it any higher the tip would hit the bumper and...

As the title says I have a vibration with my IRS on highway speeds, mostly around 80 letting off the gas. The IRS is all stock with 18k, stock 03 cobra driveshaft, built T56. I'm not sure if this is the driveshaft indexing as I read if you spin the driveshaft 1/4 turn the vibration could...

Hey guys. I recently finished up my IRS install but I believe my rear tires are rubbing "something". I am running Eibach pro kit springs with poly isolators (not very low by any means). I also have 295/35/18 BFGs on Afs03 18x10.5 wheels. Anyone else using this setup? My fenders are not rolled...

Silly noob question but is it possible to remove the diff cover on the IRS with the housing still installed in the subframe? The subframe is out of the car. Just wondering how tough it is to get that cover off without taking the housing out of the subframe?

Does anyone know if you can swap between say Touring and Stinger mufflers on the same catback? Or are the catbacks different?

Up for sale is a used MAC Catback for 96-98 Mustang GTs. It's a couple years old but on a car that is rarely driven, no rain or snow etc. Sounds awesome only selling because I'm swapping to IRS. Asking $200 pickup only. Link: http://www.americanmuscle.com/mac-catback-9604gt.html

Anyone paint their undercarriage with POR? I'm pulling my rear end and gas tank and wanted to clean up and paint under them while they are out but having a tough time deciding. I think the gray POR15 would look clean. Anyone have any experience with this?

Up for sale is a used MAC Catback for 96-98 Mustang GTs. It's a couple years old but on a car that is rarely driven, no rain or snow etc. Sounds awesome only selling because I'm swapping to IRS. Asking $200 pickup only. Link: http://www.americanmuscle.com/mac-catback-9604gt.html

Up for sale is a used MAC Catback for 96-98 Mustang GTs. It's a couple years old but on a car that is rarely driven, no rain or snow etc. Sounds awesome only selling because I'm swapping to IRS. Asking $200 pickup only. Link: http://www.americanmuscle.com/mac-catback-9604gt.html

Just wondering what you guys living in the North East with long commutes daily drive for the winter? I commute to NYC which is about 60 miles + one way, so daily driving a truck or jeep is pretty much out of the question. I drive a new Jetta TDI so the mileage is awesome and in the winter I put...

As the title says I have a brand new in box Evaporator core and Heater core for 94-04 Mustangs. These things are just taking up valuable space in my garage. PM me if interested.

Hey guys. Past few weeks my intercooler pump has been making some noise, pretty loud as you hear it over the motor running at idle. It's still circulating water fine. Could it be air in the system? If so what's the best way to get it out as there's no bleeder on the system?

Hey guys, haven't posted on here for a while, just wanted to give an update on my SN95 project and share my experience with Kevin @ Wicked Motorsports. Short story of the car- Besides the obvious mods, it has a '04 Explorer PI aluminum longblock, built rear end with 4.10s, Texas Drivetrain...

Anyone have a Hess or now a "Speedway" in their area? Hess was my spot to fill up for years and now it's a Speedway, just wondering if the fuel is the same quality as I've never heard of Speedway before.. Also, if anyone has one of these stations in their area, ask for a Reward card. It's free...

Has anyone towed their car using a Uhaul trailer? If so was it a good or bad experience? I know they don't use electronic brakes which kinda sucks but I'll be mostly highway for 2.5hrs or so. Any feedback would be appreciated.

http://www.lethalperformance.com/division-x-rail-mount-mech-fuel-pressure-gauge-0-100-psi.html Anyone using this gauge? If so how is it? I have an Aeromotive that went bad on me and I just read that apparently they don't last very long.

As the title says, looking to see if any SN95 guys are running aftermarket heat exchangers. Right now I have the stock 03/04 Cobra H/E but it was a tight fight. Just want to see if anyone is running an Afco or LFP and how it fits? Thanks in advance

Hey guys. I haven't had my car out yet this summer and am starting to go stir crazy without having a project to work on. I finally was able to score a pair of these. They need a little TLC to be perfect but I needed a little project to occupy myself, lol. I was originally going to...

Hey guys, I'm looking for an old thread on Export Mirrors. I think it was on SVTP, a guy bought a set of export mirrors and replaced plastic bushings if I remember correctly. Not sure if anyone remembers but if so i'd appreciate it!

Hey guys can someone resize this pic for a sig? IT would be greatly appreciated. Thanks.

Finally broke down and bought a set of wheels for my TDI. I mounted snows on the stock wheels and don't have the time to sit at the tire shop twice a year to have the tires switched on and off the wheels. At least that was my excuse lol. Sorry for the iPhone pics

At what age is it too old to buy a new toy? I'm 25, working full time and trying to save for a house and ring for the near future, like next few years. I've been really debating calling a quits on my sn95 lately and upgrade to something new like a '14 GT leftover but not sure if I'm going to...

I'm sure thousands of people have done this but looking for some pictures or any useful tips. I plan on getting a wire brush for the drill and knocking off any loose rust and then hitting it with POR15. Any ideas, suggestions?