Just install new motor, same setup except for the converter and crank pulley
fuel pressure, timing, air fuel, water/meth, boost, everything good all the way
tried new wiring harness, computer, chip, crank sensor and cam sensor
Nothing wrong with the Ford EDS
still have a 40-50 hp drop...
New PB
0-60........1.470
660.........6.023
MPH1......119.83
990.........7.748
1320.......9.291
MPH2......151.25
:burnout:
here are the links for the vid and the time slip:
2003 Ford Mustang Cobra SVT [email protected] - YouTube...
Hi all, I've just installed a set of springs Moroso trick drag, the car is really high especialy the back. i've also installed a set of ajustable moser in the rear and a set of QA1 for the front. Is there anyone running the same setup and if yes, will I need to cut the spings and where should I...
New best with 4R70W, into the 9's, stock IRS
60 ft -----------------1.564
MID MPH -----------112.22
660 ------------------6.403
990 ft ----------------8.242
MPH -----------------142.85
ET --------------------9.882
The idle is sometimes higher than normal, for example, when I stop at a trafic light, there's no vacuum leak, I stop the engine and when I restarted right away, it goes back to normal. Thanks
Finally in the 10's:
1.553 ----- 60 ft
4.308 ----- 330 ft
107.14 ---- MID MPH
6.643 ----- 660
8.568 ----- 990 ft
136.37 ---- MPH
10.289 ---- ET
:banana:
Hi guys, what do you think is the best drag wheel setup??? I use stock 17's in the front with 16's pony wheel in the back on MT ET Street's 26 X 16 X 10.5 and I did 1.63 0-60 feet. The only mod on the suspension is Eiback Pro Kit. The car is full weight. I would like to do 1,5's on 0-60. Thanks.
I have the choice to go with 16" MT ET STREET 26 X 10.5 X 16 or stock 17" wheel with HOOSIER Drag radial 315/35/17. What to you guys think will be faster at the track? Thanks.
I don't know what is going on with my coolant...I have to add about 1/2 gallon every 250 miles...I don't see any smoke in the exhaust and I don't see any bubble of air in the overflow can...the motor doesn't heat up for 250 miles....the oil of the motor is fine too....THANKS
Hi guys, I just bought and install my new KB 2.8H, should I run my water methanol kit? Is that going to hurt my supercharger in the long run since methanol is corrosive? I think my Eaton was tired a little bit, maybe it was because of the water methanol. Thanks:rolling: