rear driver side brake hangs up after new pads and rotor where installed. Put a new caliper on and still hangs up. The porportion valve would have nothing to do with this?
2000 lightning question need help with. behind the under hood fuse panel there are 2 small harnesses coming out of the main harness. 1 of the harnesses is a green orange strip and a black wire. Can anyone tell me where that harness plugs in?
at cruising speed temps reach 210-215. Fan is running and pulling good air. New radiator and water pump. Antifreeze was filled by vacuum and burped as well. Is the temps normal?
While checking out coolant system on my 1996 cobra I noticed the coolant hose that comes off the thermostat housing and goes to a nipple by the oil filter was collapsing when I reved the engine. Is that normal or what could cause it to do it?
Cooling fan was not coming on after engine reached 210 degrees. every forum I looked at said turn on ac and see if fan comes on. AC was not charged but charged it today and sure enough fan came on when ac was on. turn ac off and fan stops at 210 engine temp. If mmrc is bad would the fans work...
I have googled torque specs on 4.6 DOHC head bolts. One search stated 1st torque to 30 ft lb
2nd tighten additional 90 degrees
3rd loosen bolts minimum 1 full turn
4th tighten to 30 ft lb
5th tighten additional 90 degree
6th tighten additional 90 degree
90 degree= 1/4 turn but I do have a...
When removing the long timing chain on 4.6 do I just remove the two bolts on tensioner and remove it to get the chain off. I heard something about putting it in a vise to compress it to install. Am I on the right track.
during the process of pulling down a 1996 dohc engine (I,m new to the modular) when I pulled the intake and inspected down the runners at the valves on the heads the valves on the runner side look like they are coated with tar (oil) The runner where the injectors are look clean. I also noticed...