Search results

it comes with i think 60lb injectors msd coil packs ford racing plug wires boost a pump snow performance kit jlt cold air intake tube and sct maf sensor and i will throw in a set of imrc deletes i gave 200.00 just for them and it has a underdrive pulley too and 2 bottles of lucas supercharger...

2,800 kenne bell supercharger came off a running 97 cobra (SOLD)

3,400 has lots of extras i can send pictures

i have one

i have one

not sure if you are having the trouble still but when i installed the same jlt cold air you did on my 96 cobra mine did that would rev up then die i took it off and put my old one back on and starting running good just sayin

my engine light didnt come on but i was scanning for codes and my 96 cobra has a p1516 code bank1 but the code cleared but how much is it for you to go thru mine and repair if needed thanks

my 96 cobra clutch is toast i upgraded years ago to a 11in flywheel but a fords part guy told me my input shaft is 10 spline and diameter is 1.0625 but when i got to centerforce's website its saying 1-1/16 or 1-1/8 can some one please help me i actually thought the 99 cobra 11inch kit would be...

i purchased a set of the mmr plates off from a guy on this site but thanks for offering

hey friend do you take paypal if so lets fugure out some way for me to pay you

im interested in you imrc plates will they match up like my 96 aluminum ones do or do the mmr have a little offset like the first ones they made please let me know

i will let you know something soon my nephew is going to tig mine up but if something happens they get warped i will for sure let you know so i can buy yours

my nephew is a certified welder so im going to ask him to do it

so in your opinion thats what i should do then buy the mmr used

i just found my old imrc plates thinking of having them tig welded up that should be ok shouldnt it

are they the earlier version or the later one i read articles that they made chages to the later ones to work better and what do you think shipping would be to kimper ky 41539

i am almost ready to install my kenne bell on my 96 cobra and was looking to buy the imrc plates that doesnt have the flaps

if i remember correctly i changed to the 11ich flywheel made by findanza and it has the centerforce clutch kit in it and every week i have to adjust my steeda clutch adjuster to get a decent peddle mine is the 10 spline but im thing of having the 26 spline done to the trans

how much

as far as i know nothing is wrong with it i was just going to replace it with a new one i need my clutch replaced so i was just going to replace the flywheel too

years ago i upgraded my 96 cobra with the 11inch flywheel but i dont remember what brand and now im going to install a new clutch and was wondering what is a good quality flywheel for my car so i can pick one

i dont have a smell coming in my air vents the smell is under my car hood on the passenger side engine bay i smell it when i park my car in the garage i think your right its around my injector o-rings or the fuel rail but i will try and find a hose that goes to my charcoal canister and replace...

thanks i will i drove it again today and on the passenger side i smell gas and its around the fuel rail and i am guessing its the o rings towards the front of engine that was where the smell was strongest so i will tear it down and check the o rings thanks

let me start off by saying i have the upgraded alternator on my car and i have added a couple extra ground cables too.but the other day when it was 97 degrees out side i turned my a/c on and while on the four lane i noticed my temp hand going up to 3/4 and my volt hand was showing on the low...