Anyone have any tips for removing the bearings off the differential? Specifically the races?? I can't seem to get them to budge. I've already removed the cage and rollers.
I'm starting to think the only option left is a cutoff wheel and chisel...
Input appreciated!!!
Alright fellas,
So the time has come for a rear end rebuild. My car currently has 101k miles on the stock 3.73 rear end.... It leaks, whines like a bitch, and makes all sorts of noises.
Basically, I'm trying to decide of I should put another set of 3.73s in or switch it to 3.55s. My car is...
Gents,
I've got a dead spot/slop in my steering that's driving me nuts... It's about an inch of play whenever I turn the wheel in the opposite direction of which I'm turning.
- If I'm turning left then straighten up, there's slop.
Any ideas on what could be the issue?
Thanks,
Soooo a couple of weeks ago I installed some headers and whenever I finished I noticed a vibration in the drivetrain thought the RPM range. At some points it was so bad it would rattle the dash.... So I began taking it apart and what i believe is the culprit is a broken dowel pin (if not then...
Just ordered a set of headers and a catted x for my '11 but had a couple of questions.
1) They came with studs. Do I have to use them or will the stock studs suffice?
2) They came with O2 bung fill in screws. Wasn't really expecting these to come with them... I would've figured they came...
Anyone know what the part number is for the bolts that connect the driveshaft to the pinion flange?
It's the 6 10mm bolts. I can't find them anywhere.
Any help is appreciated!
Figured I would post a short thread about my motor swap for my '11 and what is needed. In order to do the swap for a '11-'12 car, you have two have 2 things:
1) Wiring Harness. part number M-12508-M50. ($250)
2) 3 bolt water pump from a 15+ gt. ($17)
On to the short story..... So I was out...
Searched around a little bit but couldn't find what I was looking for.
I'm planning on upgrading the struts to konis with cc plates but wasn't sure what 'year' struts and CC plates I need to get.
I know a lot of the 11-14 guys go for the 05-10 struts w/gt500 strut mounts but wasn't sure if...
Haven't been able to find what i'm looking for so figured I'd make a new thread.
Who on here is running Kooks LT's with a catted x-pipe? Doesn't seem that many people run this but maybe I'm wrong.
Just trying to get some ideas so post away!
My 2011 Mustang GT has been needing some love for a while. I finally got around to acquiring the necessities and started to do some work. This is my daily driver so I opted for a single stage correction. It was my first attempt at a paint correction and I'm pleased with how it came out, although...