Search results

I'm selling my 2003 Cobra (#5,801). The car has 16,045 miles on it. Clean CARFAX. The car was originally purchased from Montgomery Ford in Ohio. I had purchased the car in Ontario bone stock with 13,XXX miles. One of the cleanest Cobra's in Ontario. Exterior 9.5/10, Interior 9.9/10. This car...

Have a pair of Michelin PS2 tires 315/30/18 like new condition 8/32 remaining (brand new is 8.5/32) ultra high-performance sport wet/dry. had them on my AFS Cobras 18x10.5. Exceptional performance for drivers demanding precise sport handling. Original equipment on renowned sports cars like...

Just Listed...

Have a pair of Michelin PS2 tires 315/30/18 like new condition 8/32 remaining (brand new is 8.5/32) ultra high-performance sport wet/dry. Exceptional performance for drivers demanding precise sport handling. Original equipment on renowned sports cars like BMW M3, Porshe 911 and Chevrolet...

Brand New never used or installed 3.25 Kenne Bell pulley $80shipped

Belt has less than 30miles on it, changed it to a bigger after putting a 3.2 alternator pulley... basically brand new $35shipped

I need to know what size belt i would need for my setup, i have a kb with a 3.5 pulley and a 4lb lower. Im going to install a metco 4-pice idler set (3-100 and 1-90) thanks

630rwhp/597tq @ 15lbs of boost 18 Timing 11.2 Air/Fuel across the band Just with a 2.8 Mammoth (supporting fuel mods) and full exhaust... :banana:

I had a kenne bell 2.8 installed on my cobra, and the boost gauge wasnt working after the install, i figured out they connected the boost vacuum hose to the egr vacuum hose. It was tuned like that. Does that make a difference after i corrected it? Do i need to re-tune it?

Always liked the look of the 99/01 Cobra taillights. So i finally found a brand new set of lights with the harnesses, and found the install guide from another forum member BEFORE: AFTER: ME: :banana:

I have a 2.8 mammoth running a 3.5 pulley, im changing it out for a 3.25 one. What size idler pulleys should i run 3-100mm 1-90mm, 3-90mm 1-100mm... Dont know to much about these. thanks

Just a couple of shots of my Cobra, i took last week...

Ive been driving my car recently and when i get into boost runs awesome, but if i go wot i noticed at the spout of the blower alittle oil spits out. Nothing major like leaking... is that normal? or is the seal gone?

Im getting a rattling/flapping sound like when you put a baseball card on your bike and spin the wheel. I know its not detonating/pinging because ive been running racing fuel and the problem still occurs. Ive checked alot under the car and cant seem to find the problem. It happens once and...

I have been having a rattle on my car (checked the exhaust, etc.)and went under it today and i noticed the clutch cable connected to the clutch fork has play. Is that normal? i have a steeda clutch adjustment kit which includes 555-7000, Steeda Double Hook Quadrant - Steeda Logo 555-7021...

I live in canada and needed to buy two fittings from them and the want a min. $40 order and i need 2 fittings that cost .78 cents each. I wanted to know if anyone lives near there could buy and ship them to me and i could offer a alittle for the time. thanks

I live in canada and needed to buy two fittings from them and the want a min. $40 order and i need 2 fittings that cost .78 cents each. I wanted to know if anyone lives near there could buy and ship them to me and i could offer a alittle for the time. thanks

I wanted to know where to buy the elbow that the jlt pre-filter comes with? thanks

I noticed a rattling noise when i accelerate alittle harder around 2500-3000rpm then when i gradually accelerate. I have kooks longtubes and kb mammoth 2.8 installed. At idle theres no sound... Im puzzled as to what it could be, sounds like tin metal rattling on the drivers side. :??:

Looking for a driver manual side seat track from 2000-2004? thanks

As the title says looking for a manual driver side seat track 00-04 thanks