Search results

Attempted to start my 02 Mustang this week after sitting over the winter. It will crank, but not start and the theft light is flashing on the dash. I have had this problem in the past and I would leave the key in forward accessory mode for 10 minutes and it would reset and start as normal. This...

Replaced the battery in car and now I can’t get the SYNC to pair with my iPhone. Car is 2011 and phone is a iPhone 10. Any suggestions?

I put in a Ford Racing 1 piece driveshaft in a couple of years ago. I recently had to replace the pinion seal, probably because of vibration. Not a bad job but I hate the provided bolts they gave me. They have an allen head and the are not hardened steel. Any one else done this using different...

I noticed my Diff is leaking from the pinion flange. I installed a 1 piece aluminum drive shaft last year. Has anyone else had the problem? Not a terrible job to fix, but I don't want to do it just to have it start leaking again in a year.

The title pretty much says it all.

I’m looking for someone selling their Gen2r.

Getting ready to buy some DR's for 15X10 Racestars. Which do you recommend? M&H Cheaters or MT ET Steet R? I have never owned M&H, but I'm hearing a lot of good things about them. I've had good luck with MT before. Also size recommendations? Running 630 rwhp on stock suspension except LCA's.

What brand line lock do you recommend for a 2011 GT500? Also what size and brand tire to put on my 15X10 Racestars?

Just changed the oil in my 2011 GT500 with VMP supercharger. After about 2500 miles with Motorcraft 5W-50. I only have a catch can on the passenger side. This is how much it caught

Wanted to buy as a pair or individually.

How do you completely turn traction control off on a 2011 GT500? I wanted to totally burn up my old tires but every time i tried to power brake it it would go into limp mode. Hitting the button once or twice didn't do anything

Looking for a twin 67mm VMP throttle body.

I finally broke down and bought a MGW shifter for my 2011 GT500. I have had problems with gear grind since owning it and it has always pissed me off. The shifter has always felt sloppy in general. About 5 years ago i did the AmsOil tranny fluid change along with installing the aluminum bushings...

So i just did my first 1/2 mile drag/top speed event over the weekend. I have a 2011 GT500 with a Gen 1 VMP. I top speed was consistently around 144 mph. I was on stock tires which hurt me badly. Anyone else done a 1/2 mile? If so what was their trap speed. I was hoping for 150 but I can't wait...

I am doing a 1/2 mile event for speed in October, and am wondering if anyone else on here has done a similar event. I have raced the 1/4 mile plenty of times, but never anything longer. Would just like to get any tips or ideas to improve my speed. Is anyone else on here doing the same event?

Anyone else doing the Wanna Go Fast at French Lick, IN in October? It is a 1/2 mile drag racing event for top speed. I am going to participate and just wondered if anyone else on here is going. I know I am going to be slow compared to a lot of the exotics that show up to these events, but I am...

Looking to buy anywhere from one wheel or up to four. My only request is that they are in like new condition. PM or text 8124301012. Thanks

I would like to get some real life results of which driveshaft i should buy. I would like to know about ease of installation, how well it fits. Did you have to wrestle it in to place? Also in vehicle noise comparisons. Where to buy it? Thanks

Does anyone know if VMP sets a rev limiter on their tunes. If so what is it normally.

Does anyone know where to buy a OEM gurney flap? I could not find it at Tousley Ford. Also anyones experience with an aftermarket one? I have heard good and bad things about Trucarbon parts.

What is the smallest diameter wheel you can run without relocating the sway bar. Want better traction, but not crazy about cutting up the sway bar bracket.

GO COLTS!!!!!!!! Just thought i would throw that out there.

I would like some advice on getting an indoor cover. Mainly looking to just keep dust off with a little bit of ding protection. Would like to stay under $200.

I would like some advice on getting an indoor cover. Mainly looking to just keep dust off with a little bit of ding protection. Would like to stay under $200.

How wide can you go on the front tires of a 2011 GT500?