New never used speed of sound triple pod with new boost, oil pressure gauge, aero force dual obd2 gauge. $400
Sent from my iPhone using the svtperformance.com mobile app
For sale new never installed gen 5 whipple 10 rib kit with stock size harmonic balancer, three uppers included 3.75”,3.5”,3.25” arp crank bolt. Asking $1600
Sent from my iPhone using the svtperformance.com mobile app
Garage clean up sale. Some parts used others new:
New thump racing tensioner $440
New JBA long tube headers 1-3/4" $300
New MMR crank sprocket $180
New MMR 900hp 5.4L short block with OP and ARP fastener upgrade for the crank and rods $3000
Used 3.4L whipple crusher inlet and KB BOP and JLT...
Anybody recently order a triple pod from speed of sound? I have been try to do so but get no replay on my emails? I can't just place an order online as I live in Canada and the web site does not allow it. So I was trying to order by other means. Any help would be appreciated.
Sent from my...
hi all i just got a 04 mystic for my wife and i want to do some mods this winter. the car has all the stuff in my sig. what other mods should i do? i would like to get a bit more power with the overdrive pulley. But which one should i buy? is there mail order tunes that are safe? what other...
Hi all, here in Canada we have 94 octane fuel that is a blend of up to 10% ethanol. IT can be any combination of ethanol under 10% total volume. Would you guys use this as a fuel with no fuel system mods under a custom 91 octane tune?
Hi all, I have a frpp dual 65mm. And I'm experiencing some drivability issues. Ie stalling on hills. My tuner has traced it back to tps voltage. He is saying that at idle it should read 1.7v. After trying two different throttle body's I still get the same result from my data logs. It's about...
Anyone else have a drive shaft fail? I have 4000km on my car and need to replace it. Has anyone on here used a drive shaft from The Driveshaft Shop? I am defiantly going the aftermarket route on this as the factory unit is way too expensive, plus it may fail again.
The Driveshaft Shop has a...
Well I'm tired of trying to fix this 8.8 in my car. Third try was not the charm :fm: so has anyone tried an aftermarket 9 inch rear end? Is there any fully bolt on 9 inch rears out there? I have read a few people have tried the full 8.8 inch ford racing rear and still they are experiencing...
Just got my second set of 3:73 installed. First set we could not find a pattern that were quiet. Second set seem to be fine no hugely noticeable noise. BUT I also got metco uca and LCA installed at the same time. Which seem to transfer rear end noise.
Now after driving it home there is a...
Hey guys I have a few questions on installing lca. First I purchased the lower control arm mounts also. What will this do for my ride quality? Also on a stock hight car how do I install them? Which hole do I use? I bought all metco stuff if that info is need to help with my questions. Also...
Hi guys, has anyone out there done a 2.8L blower upgrade on the 5.8L? I see a lot of mag articles about the 3.6L but im not sure I want to do the rest of the modifications need to support this blower. Also I'm not sure its worth the extra cash as to really push the 3.6L you would need to build...
Hi guys i just got over the painful first 1000 mile break in. So i went out today and mashed it on a back road. it seemed fine but i notice when i revved it right out i noticed that the a/f gauge was showing 10.0 is this normal? It seemed down on power compared to other cars. do i have a bad...
anyone get ford to put in a set of 3:73 or 4:10's? can they flash the computer to maintain the factory warranty? any help would be much appreciated. I'm getting the runaround by my local dealer. They are say that FRPP dos not make gears yet but i know many have had this mod done already on this...
Hey guys anyone have pic’s of performance white with black, or Red candy and black, or DIB with black strips? I can’t choose between them and need to see a real car to make my choice.
Hi guys I was hoping I could get some help here. I'm a Canadian looking to buy a car south of my boarder. As I can save as much as 14k on price by doing so. I have heard a few people talk about the ability to buy "new" cars down south. I am looking for anyone that has done this or any dealer...
wanted to buy a clean low mod car in or around Alberta Canada can be a US car but seller must be willing to work with a Canadian buyer. I'm only looking for hard tops no verts. Also would consider 03-04 Terminator if the price is right. cash is in hand and i have a itch that needs to be...
wanted to buy a clean low mod car in or around Alberta Canada can be a US car but seller must be willing to work with a Canadian buyer. I'm only looking for hard tops no verts. also would consider 07-10 gt500 if the price is right. cash is in hand and i have a itch that needs to be scratched ...