Recent content by travix

Are there any reputable ECU repair places that you know of?

Just got your message. This sounds like just my luck.

Hey everyone, I don't post often, I usually just lurk and learn. However, this time I'm stumped and so is my tuner. I tried searching far and wide for something close to an answer and found nothing. So here goes. 1999 Cobra that has a terminator swap. ZMR3 PCM. At idle the Bank 2 (driver side)...

Hello all, I currently have an issue with the speedometer in my car. It is a 99 cobra that has had a termi swapped in with a t56. The issue I am having started out of nowhere. The speedometer will read nothing a a little bit until the car warms up or drives a bit then it'll act like it's...

Hello all, I recently swapped a 2003 cobra engine and T56 into a 1999 cobra. Now I have a ton of parts and a good 1999 aluminum block 4v cobra engine and 5sp trans. My original plan was to find a gt body and throw the 99' engine in it for a toy. But recently I've had a change of heart. I own a...

I posted this in Blower Bistro and they sent me here. Hey all, my tuner and I are stumped. Here is the the rundown, 99 cobra with a terminator swap. I have the 99 PCM. 2.93 upper, 4lb lower, 60lbs injectors, K&N FIPK. The issue that we have run into is that when we are on the dyno the bank...

Hey all, my tuner and I are stumped. Here is the the rundown, 99 cobra with a terminator swap. I have the 99 PCM. 2.93 upper, 4lb lower, 60lbs injectors, K&N FIPK. The issue that we have run into is that when we are on the dyno the bank 2(driver side) o2 sensor starts going super lean at 2300rpm...

Hey, I recently did a terminator swap on a 99 cobra. Everything went well, just waiting on the funds to get it to the dyno and to turn the PATS off. But, my issue is that my front swaybar is laying on the neck of the oil cooler when there isn't any weight on the car. I never had this issue with...

Hey guys, I'm looking for the pinouts for the engine harness for my 99 cobra. I am finding the 96-98 cobras and 03/04 cobra 42 pin connectors but nothing for 99/01. Please help.

Hey guys, new here but I've been trying to read and search for a couple weeks now to no avail. To the issue, I've got a 99 cobra vert and I am doing a terminator swap on it. I have everything, all harnesses, engine, tranny, driveshaft, gauges, fuel tank, the works. Now, my question is, do I...