That was the only thing not addressed in this thread. Between 5 and 10 pounds of Preload is What's necessary but that will change slightly depending on what Clutch you are running.
I just finished doing my Install and ran into some issues that dont need to be addressed and some that do. Feel free to call me and I'll give you my input if you would like it. my name is hunter. Just pm me and I'll shoot my number to you.
I have a set of pistons and wrist pins that came from an 03 or 04 lighting. I'm looking at selling them but not sure what they are worth. I didn't find much the first time I looked so No flaming if I'm blind. Just looking to make a few bucks on them and possibly help a brother out.
Does anyone have a link to a thread on this site or anywhere for that matter as to How much our 8 bolt cranks are Good for? I know they are forged but I'm putting together a budget and need to know if I will be OK with just upgrading the rods and pistons.
I'm getting ready to do the clutch mod from this thread http://www.svtperformance.com/forums/showthread.php?t=313294
I can't remember when I bought this quadrant if it was a speed release or not.
Individual prices are as follows:
Black ops $25
Mgs4 $10
orange box $30
resident evil 5 $10
Gt 5 $15
WAW $15
Heavy rain $15
Dead to rights $5
Skate 3 $15
Ac 4 $5
Army of two $5
Demons soul $10
Infamous $15
Moh limited edition $30
NCAA Football 10 $5
Uncharted: Drake's fortune $10
shipping...
My chiltons Manuel doesn't list the ohms spec for stock 24lbs/hr injectors. Says it does but I dont see it. Would any of you with stock injectors mind testing the resistance on at least 3 of your own for me? I cannot find a good source for this information. I'm guessing it needs to be somewhere...
How can you tell if you have a bad coil. I just replaced one with new one but only because the tube was very limp and not seating on the spark plug properly. Is there a checklist I can go through to find the problem?
Update: here are the plugs. Possibly oil fouled but they all look the same. I...
I searched this topic but could not find what I was looking for. I'm sure this has been asked before so if you have a link to a helpful thread that would be appreciated. I'm curious as to what is used for headers on a Turbo build. Whether the stock manifolds can be flipped over or if custom ones...
I just put another tr3650 in my 01. Replaced the pilot and throw out bearing. I have a spec stage 3+ clutch with a fidanza aluminum flywheel. Both we cleaned prior to reinstallation. Here is my problem. Before I did the swap I had a weird bearing whir sound that came from the rear of the motor...