BMR Adjustable Upper Control Arm and Mount for sale. They have never been installed. They came with the car I just purchased as an alternative route to go on the suspension. However, I decided to go with what is on the car and these are therefore now for sale.
Part numbers are as follows...
This car was built for my wife to drive. It has a ton of mods done to it that will be listed below. The odometer reads 180k but EVERYTHING in this car has been replaced. It has an engine swap from a 2004 Cobra. It has been professionally tuned after the swap. If you have any questions about the...
1999 Mustang GT LE-Roller Chassis-SOLD SOLD SOLD!!!!
I've put this car together over the past 4 years and then i had an issue that we thought was the motor being hurt. After tear down we discovered that the fuel injectors had all been clogged by sand somehow. We sent them out to be cleaned and...
FS: Cobra 9 thread Heads & more
Bazooka 95mm MAF($150)
Mac Off-Road Shorty ProChamber back half(where it connects to the flow tubes) needs to be welded in, i left plenty of material($150)
Fidanza 8 bolt Alum. Flywheel($250)
Pics of everything upon request.
FS: Dual Div X Stryker 340lph pumps/Dual FPDM Kit sold
sold sold sold
I have Dual Stryker pumps 340/lph. They only have dyno time on them.
Asking $200.00 Shipped for both (Paypal fees included)
I have a dual FPDM complete kit (minus the upgraded power wire from the front of...
FS Dual FPDM Harness---sold
This is the West Coast Mustangs Dual FPDM.
Info can be found here: WestCoastMustangs.com
(Original cost)
This includes the Dual FPDM stand-alone wiring harness ($249.00)
One Used FPDM with mounting hardware for a 2nd FPDM (without FPDM bracket) ($44.95)...
I have 2 stock cobra pumps for sale along with stock exhaust manifolds (9k on car).
PM me your offers, best offer takes them!
Would be willing to trade these as well, PM trade offers.
Up for sale is (1) Kenne Bell Boost-A-Pump unit. The Boost-A-Pump kit is the 40-Amp model and was purchased used from another member; never used on my end. Went a different route with the fuel system because of future plans (went triple pump setup for that big whipple). Local pickup welcome...
Like the title says looking to buy a 40amp BAP and a set of 60# injectors. Can post here or email me and I'll get that instantly on my Droid... [email protected]