Recent content by procharger

I've been reading a lot about this oil issue, NOTHING has been touched on piston oil return ports or any pics of the actual piston. Toyota had the same issue with their 2AZ-FE engine, I know first hand because I seen the piston after disassembling the engine in my son's 2001 Chevy Prizm...

The cobra A-Pillar is a cross between the convertible and hardtop, they will mount the same but don't look the same. Sent from my LG-H918 using the svtperformance.com mobile app

It seems everyone talking about belts, but the belts in question seem to be of top quality. Bearings used on rebuilt parts tend to be on the cheaper side, where people are not able to see or check the quality. It seems everyone talking about belts

Sounds like the voltage regulator. This part is often overlooked or must people don't know some can be replaced or upgraded. I would use a handheld meter to load test the alternator, also load test the pumps and FPDM. I would think voltage shouldn't drop under load, but maintain a steedy 13+...

Ohm engine coolant sensor or while at idle remove connector from sensor and the fans should kick on, if not your sensor is INOP. Sent from my [device_name] using the svtperformance.com mobile app

I believe the hose came off your pumps, due to the BAP pressure flowing thru 5/16 hose will have some back pressure, also stock pump do not have barbs to secure the hoses and are slightly tapered. I believe you should have 3/8 hoses, as far as keeping the hoses on stock pump it's a gamble. I...

Sounded like the computer was re-learning itself. Sent from my [device_name] using the svtperformance.com mobile app

Here you go Sent from my [device_name] using the svtperformance.com mobile app

As long as you don't change the meter foot print or increase the inner diameter of the tubing and place your meter in the same position you should be ok. Sent from my [device_name] using the svtperformance.com mobile app

Block plug used, drill out square hole DO NOT make hole the size of snout studs, bevel edge with sanding place face down into pullie, use press to insert plug, then use press on snout to lock in place on plugs DO NOT use in lube. Sent from my [device_name] using the svtperformance.com mobile app

I believe a stock lower can be used as long as the bushing do not show any damage and or not 10+ years old. I replaced mine with block plugs then pressed the snout into the plug, it provides a very nice tight fit. Sent from my [device_name] using the svtperformance.com mobile app

Double check all wiring around supercharger, sounds like once the metal expands it create a short, but it can only happen when its hot. Sent from my [device_name] using the svtperformance.com mobile app

Use a handheld to get live data on your fuel pressure. Sent from my [device_name] using the svtperformance.com mobile app

No issues, it's way stronger now. Sent from my [device_name] using the svtperformance.com mobile app

Intercooler pump Sent from my [device_name] using the svtperformance.com mobile app