Recent content by on3performance

Im curious what people are cutting with the stock converter. Please post up your times if you would

The 99 heads have only 25k miles on them and I broke a rod in cyl 8. The head needs a couple valves and maybe a slight repair but its very minimal and should be a cheap easy fix. The other head looked just fine and both are complete with valvetrain, cams, etc $600 the 03 heads were just at...

I had an 03 motor in my notch and just decided we are going with a single turbo setup instead now. I pulled all of the parts and installed everything from a 99 cobra to go back to na. I have cut most of the cooling lines and just used a lot of 3/4" heater hose to route everything. The only...

Looking for a set of assembled heads ready to bolt on. I have been considering the Livernois as I know its an excellent head but just a lot of money. Not sure I want to put that much into this setup as Im shooting for the 750-850rw area. If anyone is selling, please email photos or pm me...

Its all basically new, blower really doesnt have more than 30 miles on it. I bought the billetflow plenum to get matched to the blower port and an accufab throttle body. $1400 Going turbo

taking the 03 motor out of my notch to just go turbo like I should have from the start. I have a 99 currently blown up and was going to throw it in the 99 and put the new stroker in the notch with a big single. Anyone know if I can clear the stock 99 hood?

I have been in the middle of deleting mine in the 03 swapped fox coupe Im doing. After reading and reading on how people are getting rid of it and having all the issues, including myself with hose kinking, I made my own solution. The hose shown was just for mocking up my setup and will get...

I have the 03 motor in a 90 notch and dont have any of the emissions equipment on the car. We are using the 03 tank as well and does anyone know if I can just put a breather on the end of each of these? I assume the 2nd photo normally goes back into the filler neck but its modified to fit the...

I have the 99s on a shelf and boxed up right now and just had someone offer a few valves from a old 03 head. Can anyone verify that we can use an 03 valve in a 99 4v head? I will measure tomorrow but was trying to get an answer tonight

I need the harness under the hood that attaches to the relay/fuse block If you have one please let me know

Picked up a ported blower and have this sitting around. 40k miles on the car when it was pulled $300 + shipping

I just picked up a ported blower that is going on our notch we just swapped a 03 motor in. Is that gasket something I reuse or do I need to order another one?

I would like to buy complete sets of take out 03-04 39# injectors. PM me, Ill pretty much buy as many sets as I can(That is if the price is right)

If anyone has a setup to sell, let me know

I have had some some people call me about my car and it has a salvage title so its not perfect. As far as the body though(shell), it doesnt have any front end, rear end or any other significate damage. A few dents in the driver quarter and some dents in the roof that could be pounded out...