Recent content by mustangmatt86

I sold my 04 OW cobra last August to a guy in NC, car then went to Michigan. Now last I recall is car went to Wisconsin. Car had whipple 2.3, cams, lethal budget return kit, black cobra wheels, solid rear, I sold it with 79xxx miles. Guy in NC added meth to it. Would like to find it and...

looking to buy a 03 04 cobra in south NY, north NJ, eastern PA, or western CT im preapproved for 18k anything but black must be coupe NO VERT thanks matt

Like the title says, looking to trade my 2004 OW cobra for a fox and cash, looking for semi built coupe, lx, or maybe gt, no verts, looking for a trade with around 10k-15k depending on cars value for my car looking for 11,500 - 13000 on top of a car Located a hour north of NYC Call or text...

SOLD SOLD SOLD 2004 Ford Mustang SVT Cobra 80000 miles 6 speed Oxford White exterior Black interior $18000 obo Will trade for fox and cash, need atleast $10k on top of car car dyno'd 580/570 Modifications: Whipple 2.3 supercharger @20psi Stage 2 comp cams Bbk long tubes Bbk off road x pipe...

WTT 04 OW cobra for fox plus cash im not 100% sure if im going to sell or get rid of the car, im just seeing what offers I can get 2004 Ford Mustang Cobra oxford white 77xxx miles 585hp 570tq Engine: stock block bored .20 over with je pistons stock heads completely redone within 1000 miles...

Alright well I can check off a 10 sec pass off my list finally. It's something I've been shooting for, for a while now and I gotta share it. The car: 2004 cobra, Whipple 2.3 @ 20psi, 3.5 upper 6lb lower, lethal budget return kit, 2 400lph pumps, 60lb inj, sct2400 maf, bbk long tubes, o/r mid...

alright, so i got a 04 cobra and i noticed a very strange and annoying noise, its hard to explain, its not a knock, rattle, whistle, or tick but more of a kind of clanking. it makes the noise at idle, it kinda fades away with rpms, and when i turn the car off it rattles down till the motor...

well heading pretty much sums it up the cars: 04 cobra, whipple 2.3 @ 18psi, 93 octane, 6spd, mt et street 2 radials, tuned 575hp 570tq 90 mustang lx, 363 stroker, heads cam intake, 76mm turbo, c4 auto, drag suspension, tuned, supposedly 600hp but idk, radials n slick this race has...

hey im sure this is in the wrong forum but I had no responses in the driveline section so a while ago I broke the fingers on my act street clutch, I got a spec 2+ clutch and billet alum flywheel, new tob and pilot bearing. after installation I noticed a vibration at 1500 rpm, then tob...

up for sale is my steggy stage 3 ported eaton, ported plenum, and ported stock throttle body. upgrading my setup to a whipple. works perfect, no unusual noises, made 520hp 545tq, only boosted to 16psi and never has gone over that amount of boost. 6000 miles on ported setup and rebuild...

Im having a wierd vibration out of my car in the 1500 rpm range. I can feel it in the shifter. My trans makes a lot of noise but, when i push the clutch in it goes away. I recently put a spec 2+ in, and when i did it the end fingers on the fork broke off n throw out bearing started making noise...

hey svtp, im looking into upgrading from a ported eaton to a whipple setup or maybe a kb, but id prefer to do a whipple. the car was built by Jroush06 who sold it to someone who sold it to me the current setup is: 520hp/545tq stage 3 ported eaton 2.93 upper pulley, 6lb lower 60lb...

heres a vid of me doin a quick powerbrake to a rolling burnout cobra burnout video by mja6986 - Photobucket

Looking into getting a 2.8lc kb mammoth or a 2.9 whipple for my 04 cobra. I want to hear some diff opinions on each from people that have them Thanks matt

hey im new to owning a cobra and i have a few questions. heres the link to the car i purchased 2004 Cobra 1st, whats the right way to adjust a firewall adjuster for the clutch, i think its a steeda, its blue, and it has a aftermarket quadrant with a factory cable 2nd, idk if its just me...