Recent content by MOmystic

Actually need one for a 97 or 98…

Nice!

Looks clean. Thanks for the reply

What’s everyone using for their line lock activator button? Any pics? I was thinking of running a shift knob with a button on the shifter but thinking it may get in the way. Either way I’d like a clean install and not use the one that came with the hurst kit.

Can anyone point me in the right direction if anyone sells the plastic radiator support cover for a 96 cobra? Hell I’ll even consider an aftermarket metal or carbon fiber one if it’s reasonably priced.. thanks in advance

Here is the dyno graph with the 2.95 pulley. Cars peak hp was at 6500rpms. Believe the car is at 16.5* of timing and didnt like anymore timing after that. I’m gonna have them throw a 93 octane tune on it. Think i overfilled with setting it up for E85 unless i go with a bigger blower set up or...

Thanks

Will Will do!!

Thanks for your help. Greatly appreciated.

With a 12% od crank and a 2.95 blower pulley i was thinking of switching to, I’d be spinning 6,400rpm’s over what vortech claims is acceptable at 7000rpm..

Thanks

So i have basically run out of options at this point for my setup making more power, correct? Only thing i could do at this point is overspin the Ti trim?

Believe it was outer diameter

Curious as to how much you guys are overspinning your superchargers to get your results? I have a V1-Ti and will most likely be overspinning approx. 6,400 rpm’s with a 12%od crank and a 2.95 upper at 7000 rpm according to the Vortech calculator. Anyone else overspinning?

Gonna swap to a 2.95 blower pulley and see what it does and go from there…