I have a PA Performance 170amp Alternator.
Used less then 5000 miles.
I had a larger pulley on it to slow it down, so its had a super easy life.
Price: 235 SHIPPED
SOLD OUT
I have 1 head cooling fitting you can use to do your own head cooling mod or use the to run -an fittings to radiator.
I do have the hold down plates but they are not pictured.
Price: $20 Shipped each
[/IMG]
Purchased:
6 - Blown98riored
1 - omj
.
Radium Multi-Pump Surge Tank
Setup up for 1-3 Walbro 400/e85 Pumps
Brand New Never used
Price: 330 Shipped
If you wan more info about it
Multi-Pump Fuel Surge Tank
FS: 03 Cobra Steeda Springs FRONT AND REAR
Only 4000 miles
$225
FS: 03 Cobra Coils
Work perfectly, 35,000 miles
$80
FS: 03 Cobra Coil Covers
Just need cleaned up
$40
FS: 03 Cobra Oil Cooler
No leaks, good shape
$200
FS: 03 Cobra A/C Compressor
Working 35,000 miles...
I have a set of Lethal's Division X Rails. I had them on my whipple 2.9L build.
Passenger side has been shaved a little to clear the 2.9L stock elbow but does not effect performance and isnt noticeable on the car.
I will include the FRPS block off.
Fitting are not included.
125 Shipped
Magnafuel ProTuner 750 4303
Used less then 3,000 miles. Awesome pump, never had a single problem with street cruising even in the dead of summer.
350 shipped
I will also include the aeromotive -12 an pre filter, stainless and the lines you see in the picture.
450 shipped
I am looking for fr500 heads that are junk. I really only need one head, all it needs is two cylinders that have good ports. The heads will go to my local shop, Smithberg Racing.
Let me know what you have.
So i ordered a short block from MMR and received it. I am planing on going turbo, I will say i WILL NOT see over 1400 Flywheel Hp.
On a local forum, one of the members went to say i picked the wrong short block and he would NOT run it past 1000 flywheel horsepower.
I want to see what you...
FS: 03 Mach 1 Intake Upper and Lower and throttle body
I was going to use this on my turbo build but I picked up a Sullivan.
Its off a car that I am also doing a eaton swap on. Car has less the 40,000 miles.
I will post pictures first thing tomorrow.
Asking 350 shipped.
It is still on the...
I am parting out an 03 cobra IRS
IRS Aluminum 31 spline Center section.
Stock gears, no noise, comes with front mounts and rear as well.
I can open it up if you like. 100% complete
Asking 500 shipped for everything
03 cobra 31 spline axles
Great shape, boots are still...
Ported FR500 heads. I just purchased these a couple weeks ago.
They have valves, springs, adjusters, and arms. No cams.
They came off another forum members car with low mileage. As far as I know they are good, no warpage. I would have a machine shop check then out to be 100% sure.
I just paid...