Before I put my car in the shop earlier this week I noticed when I started the car up it sounded like something was rattling around in the engine or close too it. When the car ran for a couple of minutes it seemed to go away. Car runs fine, shifts fine, etc. I noticed it 3 different times...
Developed a small pinhole where the paint came off and was down to the primer. They said it was covered under warranty and will start on it Monday. This is the first quality issue I have had to address with the car, knock on wood.....
Also got to see the GT-40 at Payton-Wright dealership in...
The timing adjustment on predator is in percentage. Is there a way to tell what the timing is set at in the car before making an adjustment. Or is there a set method like 2% is equal to 1 degree of timing? I'm not sure if there is a way we can read what the timing is set to at WOT using the...
Does anyone know if there is a TSB out from Ford because of paint chipping on our hoods? I thought somewhere a while back someone had posted on this. I have a small paint chip on my hood that definitely did not come from hitting something in the road, just the size of a pin head but down to the...
I don't know if this board is under going maintenance or what but it has been running terribly slow when I get on. Am I the only one having this problem? I don't notice it on some of the other forums
Hey I was wondering if anyone is driving with 285/17's on all 4 tires. If so how does it drive, meaning does the front end kind of wander around when driving or does it feel like the stock tires?
Had my LT's put on and they had to drop the K-member, or should I say they chose to drop the K-member. I dropped the car off at the dealership this morning to have the alingment checked and noticed that something up front is making a chirping noise. The break system feels fine but it's...
Well first let me say thanks to Anthony at JDM, great customer service and did everything he said he would the first time without me having to follow up with the order.
I got the stainless longtubes and the shorty H-pipe without the cats since my Magnaflows are still real new and I didn't...
I have a RR 2.75 ultra grip pulley & the 4 Billetflow idlers. I believe 3 of them are 100mm & 1 is 92mm ? Is it true with this setup I can use the stock belt or do I need some other size ?
OK I did it, JDM made me a good deal on the Kooks stainless LongTubes and a stainless shorty H-pipe without cats. Has anyone in the Dallas area had success with a local shop installing these ? They will be here next week so I have some time to find a good place.
Stupid question but got to ask. When loosing the belt tension for doing a pulley swap. I know you are suppose to use a 1/2 inch socket and push towards the driver side. But which side of the adjuster to you put your socket in ? One side has an idler pulley (right) attached and there is a...